+ All Categories
Home > Documents > NanoSAR Datasheet

NanoSAR Datasheet

Date post: 11-Dec-2015
Category:
Upload: stanley-ochieng-ouma
View: 53 times
Download: 10 times
Share this document with a friend
Description:
Datasheet
Popular Tags:
2
IMSAR’s NanoSAR ® C enables cost-effective detection, location, and classification of targets in rain, snow, fog, dust, smoke, and darkness, where other sensors fail. TIER I OR II PERFORMANCE IMSAR’s NanoSAR C generates detailed real-time aerial radar images from a payload small and light enough to be mounted in a Tier I or II UAV. NanoSAR C is integrated with IMSAR’s Lisa Ground Station™ and Viper™ communication link to provide a cost-effective plug-and-play radar imaging solution. COMPACT The NanoSAR C is the world’s smallest SAR, with the REI weighing only 1 lb and the entire assembly only 2 lbs it consumes less than 25 W. The NanoSAR C radar, turret, antenna, and cabling total less than 86 cu in, and can mount in a 7 inch diameter wing-mounted pod, or inside the aircraft fuselage, with room to spare allowing for other sensor payloads and extended system endurance. INTEGRATES WITH IMSAR SYSTEM COMPONENTS NanoSAR C communicates with Viper tm and Lisa Ground Station tm to enable real-time monitoring and control of NanoSAR C and real-time analysis of SAR data. ALL WEATHER, DAY AND NIGHT SENSING NanoSAR C can operate day or night, in rain, snow, fog, dust, or smoke.
Transcript
Page 1: NanoSAR Datasheet

IMSAR’s NanoSAR® C enables cost-effective detection, location, and classification of targets in rain, snow, fog, dust, smoke, and darkness, where other sensors fail.

TIER I OR II PERFORMANCE

IMSAR’s NanoSAR C generates detailed real-time aerial radar images from a payload small and light enough to be mounted in a Tier I or II UAV. NanoSAR C is integrated with IMSAR’s Lisa Ground Station™ and Viper™ communication link to provide a cost-effective plug-and-play radar imaging solution.

COMPACT

The NanoSAR C is the world’s smallest SAR, with the REI weighing only 1 lb and the entire assembly only 2 lbs it consumes less than 25 W. The NanoSAR C radar, turret, antenna, and cabling total less than 86 cu in, and can mount in a 7 inch diameter wing-mounted pod, or inside the aircraft fuselage, with room to spare allowing for other sensor payloads and extended system endurance.

INTEGRATES WITH IMSAR SYSTEM COMPONENTS

NanoSAR C communicates with Vipertm and Lisa Ground Stationtm to enable real-time monitoring and control of NanoSAR C and real-time analysis of SAR data.

ALL WEATHER, DAY AND NIGHT SENSING

NanoSAR C can operate day or night, in rain, snow, fog, dust, or smoke.

Page 2: NanoSAR Datasheet

OPTIONS

extended range

dual pole/interferometry

moving target indicator

change detection

IMAGE PROCESSING & EXPLOITAT ION*

lisa image

lisa change

lisa 3d

Real-Time Image Processing

Change Detection

Image Exploitation, Control & Flight Planning

MODES*

operating mode

command & control

communication

sensor cueing

image products

Stripmap, Spotlight, Circular, MTI

Lisa 3Dtm & Lisa Dashboardtm

Serial, Ethernet

Cursor On Target

kml, complex NITF, jpg, png, bmp

SWAP WITH ANTENNA , GPS & IMU*

size

weight

power

supply voltage

5.5” x 3.5” x 2” + Antenna + IMU

1-3 lbs

25-70 W Consumed

12-28 V

* Range, range resolution, power, SWaP, available modes, and options vary depending on frequency and configuration.

KEY SPECIF ICAT IONS*

range resolution

standoff range

slant swath

frequency

very fine, 0.3, 0.5, 1, 2, 5, 10m

1 - 16 km

2k - 4k Resolution Cells

© 2014 IMSAR LLC. NanoSAR®, Lisa GS™, Lisa 3D™, Lisa Dashboard™, Lisa Imager™, Lisa Guidance™, Lisa Change™, Lisa Elevation™, Viper™, Falcon™, IMSAR™, The Radar Revolution® and all associated logos are trademarks of IMSAR LLC. All other product or brand names as they appear are trademarks or registered trademarks of their respective holders. The Company shall not be liable for any errors contained herein or for any damages arising out of or related to this document or the information contained therein, even if the Company has been advised of the possibility of such damages. This document is intended for informational and instructional purposes only. The Company reserves the right to make changes in the specifications and other information contained in this document without prior notification.


Recommended