2
Be sure to shop our online store for the best deals: www.uprproducts.com 750 Eastcoast St South Lake Worth, FL 33460 561-588-6630 Fax: 561-585-4141 www.uprproducts.com UPR 15-17 Dodge Hellcat PLUG N PLAY ™ Catch Can Instructions *Average install time 10-15 minutes UPR Catch Can Installation Steps: 1. Remove the factory Fuel Rail Cover by gently pulling up to get them off. 2. Remove the factory PCV line from the passenger valve cover aKa dirty side connection (This connection will have a small tab you will push over to release the fitting) 3. Remove the factory PCV line from the Supercharger inlet aKa clean side connection (This connection will be a push button clip to release the fitting) 4. Now remove the bolt from the tensioner bracket with the wire harness attached to it 5. Now Attach the UPR Supplied Catch Can Z-Bracket with the supplied UPR Shoulder Bolt (Be sure to position the UPR Z-Bracket Vertical before final tightening) 6. Now you can attach the aKa dirty side line to the UPR Catch Can Inlet / Dirty Side (UPR Plug N Play Fittings just need to be pushed on till it clicks for installation) 7. Now you can attach the aKa clean side line to the UPR Catch Can outlet / Clean Side (UPR Plug N Play Fittings just need to be pushed on till it clicks for installation) 8. Be sure to final tighten the UPR Quick Release Knob once the installation is complete 9. Check the UPR Plug n Play™ Catch Can every 1000 miles to stay on top of your engine 10. To check your UPR Catch Can just grab the top then twist the bottom of the can open Be sure to check out our Clean Side Catch Can CSCC™ Driver Side Catch Can for your HellCat. NEVER RETURN OIL FROM THE CATCH CAN BACK INTO THE ENGINE Nothing is easier or more straight forward than a UPR Plug n Play™ Catch Can System! UPR Consistently Delivers the Best Performance.
