Date post: | 01-Jan-2016 |
Category: |
Documents |
Upload: | ronan-hooper |
View: | 31 times |
Download: | 0 times |
OH Lead Area- Post May Repair
Bracket added to replace broken bolt during repair of OH lead in May 2010
Lower Lead LocationPossible OH short location through void to OH tension tube via support plate that has been removed.
Crack or void in outer groundwall insulation
Charred insulation from OH lead fault in 2007
• Clean void in insulation and surrounding area using ethanol, Q-tips and scotch-brite• Thoroughly dry insulation area• Fill void area with Hysol 3561/2039 and glass bead- slurry mix• Overwrap repair area with (2) layers of epoxy/glass tape• If possible add Kapton around steel pins to further isolate OH leads from tension tube• Allow epoxy 24 hour cure• Electrical test OH repair• Restore OH/TF bus links and umbrella lid
Recommended Repair Steps