2
OmniDELe OmniDELe binlifts | sideloaders | weighing & ID | data solutions Low Voltage, Low-Level Automatic Binlift Electric OmniDEL is a low voltage, electric bin lift with a proven heritage offering e robust build, safe operation & minimal maintenance. The OmniDEL shares e its mechanical design components, efficiency saving features and safety enhancing benefits with the standard OmniDEL but requires only 24v chassis electrical power for operation; Environmentally friendly performance as standard Designed to be compatible with future developments in electric & hybrid RCV technologies, the OmniDEL is equally compatible with diesel powered e RCV’s but because it relies on electrical power alone offers significant savings in fuel consumption and CO emissions. 2 Practically silent operation The OmniDEL is extremely quiet, producing less than 57 dB(A) of noise in e operation. Combined with its ability to operate without the engine running this is great news for light sleepers. Minimal chassis and body preparation Requiring only electrical power, the OmniDEL negates the need for a e second pump on vehicle chassis’ & requires no hydraulic preparation. OmniDEL therefore offers a straightforward ‘bolt on, plug in & play on’ e system to significantly reduce fitting times & body preparation costs. Reduced maintenance and increased durability Vibration resistant IP69K ‘plug and play’ components, bearing protection systems & contact-less wear-free angle sensors offers superb resistance to steam cleaning duties & the harsh environment of modern bin collections. Complete spillage protection system OmniDEL incorporates a unique sonar sensor anti-spillage system and e tough extensions to the clamp and hopper plate. The system detects materials that are not fully discharged & automatically shakes the bin until discharged. The extended clamp & hopper plate sections overlap during discharge to provide a platform that directs any potential spillage into the hopper. Designed with dynamic weighing and RFID in mind The OmniDEL is designed to integrate easily with weighing and e identification systems, has a smooth operation to minimise 'bin bounce ' and a vertical initial lift providing a 'window' for ease of data recording. Lightweight design, heavyweight performance The OmniDEL bin lift weighs in from as little as 635kg. e ’Plug and Play’ wiring connections reduce downtime The OmniDEL is designed to reduce downtime during unlikely repair e work. All connections are 'Plug and Play' and easy to access, making replacement of defective components and/or wiring simple and fast. An intelligent diagnosis system simplifies the fault finding process. Automatic Mode Changeover OmniDEL features automatic cycle mode changeover, offering ease of e operation and safety. As trade containers are presented, the intelligent control system selects ‘trade’ mode and catcher bar to the correct position. Both chairs are levelled/raised to the optimum height & the bin lift engages the bin to allow a safe, manually controlled cycle. Rear Protection Device (RPD) Rear underwalk protection as standard ensures compliance with the requirements of EN1501.5.The sensor arrangement employed ensures that bin lift chair movement is frozen if a person (or obstruction) is detected inside the functional working area and the container is above 1000mm. Single Point Greasing A single point greasing system is fitted as standard offering reductions in maintenance times, grease lines are protected from damage & provide grease to all nine lubrication points. Smooth, two-stage soft lift The OmniDEL has a controlled two-speed lifting cycle with a safe, smooth e & reliable bin pick up to reduce mechanical stress on bins & the bin lift system. Unique Terberg Geometry Terberg’s unique bin lift geometry gives a container tip angle of 50° ensuring that ‘sticky’ materials are discharged and eliminates bin ‘kick out’ during lifting to reduce the likelihood of injury.
