Pre-amplifier achieving up to 200 km without any inline locationBy the additional use of a pre-amplifier at the end of a transmission link the achievable distance of the
entire system can be increased up to 250 km (e.g. with 1 Gbps signals).
Optical EDFA amplifier
One pair of fiber
Without inline locationUp to 40 x
Location A
SPEED-DWDM
1 GbE switch
1 GbE switch
1 GbE switch
1 GbE switch
SPEED-PREAMP and SPEED-BOOSTER
Location B
SPEED-DWDM
1 GbE switch
1 GbE switch
1 GbE switch
1 GbE switch
Up to 40 x
SPEED-PREAMP and SPEED-BOOSTER
Up to 200 km
SPEED-BOOSTER for 10 Gbps point-to-point connections up to 170 kmDistances of optical transmission systems can be increased by using optical amplifier. Three different amplifier types (booster, in-line ampli-fier and pre-amplifier) can be used depending on the required distance and existing locations. All SPEED amplifier are capable to transfer up to 80 DWDM wavelengths via a single pair of fiber.
Each wavelength supports miscellaneous proto-cols like SDH, ATM and Ethernet providing and bandwidths (10 Mbps to 100 Gbps).The amplifier can be monitored and configured locally via CLI (Telnet) or through SNMP and Web GUI by using the optionally available ma-nagement module. Even a remote management
can be enabled by an in-band OSC channel. All optical SPEED-amplifier meet laser safety class 1M. The modules are installed in space-saving housing types (SPEEDCARRIER 5U and SPEED-CARRIER 1U/B). Up to 170 km can be accom-plished in a point-to-point connection by using a booster at the beginning of the line.
� Optical amplifier: Booster, in-line amplifier, pre-amplifier � Distances: Above 1,000 km without signal regeneration � Protocol transparent (10 Mbps to 100 Gbps) � Laser safety class 1M � Customized amplifying design available on request � Optional: Remote management via OSC channel
Optical EDFA amplifier for long-haul application – DWDM and 40/100Gbps signals above 1,000 km
100 Gbps above 1,000 km using booster, pre-amplifier and multiple in-line amplifier
SPEED amplifier options
SPEED-AMP EDFA
Up to 10 x
Location A Location B n x Location Z
SPEED-DWDM SPEED-DWDM
More than 1,000 km with multiple inline locations
More than 1,000 km possible
10 GbE switch
10 GbE switch
10 GbE switch
10 GbE switch
10 GbE switch
10 GbE switch
10 GbE switch
10 GbE switch
Up to 10 x
SPEED-PREAMP and SPEED-BOOSTER
SPEED-PREAMP and SPEED-BOOSTER
SPEED-INLINER
Up to 40 x
Location A Location B Location Z
SPEED-DWDM SPEED-DWDM
One inline location
1 GbE switch
1 GbE switch
Up to 400 km
1 GbE switch
1 GbE switch
1 GbE switch
1 GbE switch
1 GbE switch
1 GbE switch
Up to 40 x
SPEED-PREAMP and SPEED-BOOSTER
SPEED-PREAMP and SPEED-BOOSTER
SPEED-INLINER
Up to 400 km without signal regeneration using one single in-line amplifier even for 100 GbpsIf the availability exists to install one or more in-line amplifier at a repeater site, the DWDM signal can be intensified with additional 23 dBm power budget. Using one repeater site, a distance up to
400 km can be realized whereas this can be fur-ther extended if more repeater sites are used. All three types of amplifier are already designed to support 100 Gbps bandwidths for realizing up to
1,000 km in a point-to-point connection. For this purpose multiple repeater sites and a Forward-Error-Correction (FEC) integrated in theused optics are required.
Ordering number Product name Type Output power Input sensitivity Number of slot Ethernet Port RJ-45 Ethernet Port SFP OSC
S-OBA-17-A SPEED-AMP EDFA BI Booster and Inliner 17 dBm -25 dBm 2 2 1 Integrated
S-OBA-23-A SPEED-AMP EDFA BI Booster and Inliner 23 dBm -25 dBm 2 2 1 Integrated
S-OPA-14-A SPEED-AMP EDFA PRE PreAmp 14 dBm -36 dBm 1 2 1 Not integrated
General•LED indicators: Unit status, optical link, OSC status,
Ethernet link•Inliner/Booster(HxWxD):56x131x170mm•PreAmp(HxWxD):28x131x170mm•Power supply via backplane•Inliner:15W•PreAmp:12W•Laser safety class 1M
Optical interfaces•Booster / in-line amplifier: 2 x LC duplex connector•Pre-amplifier: 1 x LC duplex connector
Management•Telnet, CLI•SNMP and Web GUI by using a management module (SPEED-
NMS OE)•Remote management provided by OSC channel (1510 nm)
