PLI RoHS Usage Introduction

Prepared by Robin Ji

Where is it… (1)• Design Parts• Specify the part RMB View• Go to RoHS tab

Where is it… (1)

Where is it… (2)• Design Parts• Specify the part RMB View RoHS

When and how to set or edit it

• When: Properties can be edited during any state of the lifecycle of the part (New - Obsolete)

• How:Lock the RoHS form and edit any of the 3 available properties.

When and how to set or edit it (1)

• RMB on the part number under RoHS tab View RoHS

When and how to set or edit it (1)

• Lock the RoHS Form for edit• Save, Unlock and Close

When and how to set or edit it (2)

• RMB on the part View RoHS

RoHS signoff in ECN

• What condition:1. Production ECN2. Affected item with RoHS set to HIGH/NULL

RoHS signoff in ECN

• Sample 1. HS0001 NULL2. HS0002 HIGH3. HS0003 LOW4. HS0004 NO5. HS0005 PBB NULL RoHS20116. ECN002888

RoHS signoff in ECN

RoHS signoff in ECN

RoHS signoff in ECN

BOM Report with RoHS• RMB on the specified part Single Level BOM

Report

BOM Report with RoHS• RMB on the specified part Multiple Level

BOM Report

Tips

• ALL electronic or electro-magnetic part will always be cataloged as HIGH independent to the RoHS Compliant designator.

Tips