polaris® rzr® xp1000

2014-2016 Polaris® Rzr® xp1000

kit includes

RDS-Series ® Roof Mount

Installation Instructions

Fits (1) 30” RDS-Series

(1) Mount #46531

*Lights sold separately

Thank you for purchasing Rigid Industries® products for your Polaris®. Installation is fairly simple with the right tools and good mechanical abilities. If you are not confident in your mechanical skills, please seek the help of a professional to perform the installation. Please read through all of these instructions and tips before proceeding with the installation. It is strongly recommended that this product be installed by a professional.

Important

step 1 step 2

Remove and save (2) T40 torx bolts on each side and remove roof cover. See Figure 1.

Remove and save (2) 15mm bolts on each side. See Figure 2.

Figure 2. Figure 1.

Always disconnect any power sources connected to your vehicle before servicing fuses or electrical systems.

779 N Colorado St, Gilbert, AZ 85233 • 855-760-5337 • www.rigidindustries.com

PKG-IS-141-BRigid Industries, Rigid, RDS-Series are registered and/or common law marks owned by

JST Performance, LLC, a Delaware limited liability company d/b/a Rigid Industries.

Your installation is now complete.Welcome to the Rigid Nation!

step 4 step 5

Re-install (2) screws saved from Step 3 on each side. See Figure 4.

Re-install (2) screws saved from Step 1 on each side. See Figure 5.

Figure 5. Figure 4.

step 6

Install your Rigid Industries light bar using the hardware provided with the light.

Wire your lights according to the instructions included with the light. Take care to avoid any heat sources and sharp or abrasive surfaces.

step 3 Figure 3. Figure 3.1

Place Rigid Industries mount between roll cage and roof bar and re-install (2) 15 mm bolts saved from Step 2 on Driver’s (marked D) and Passenger’s (marked P) side. See Figure 3.

Follow us on facebook at Facebook.com/RigidIndustries

For warranty information, visit www.rigidindustries.com/about/warrantyWARRANTY INFORMATION