polycom , group series, setup, hardware

© Polycom, Inc. All rights reserved. Specifications are subject to change without notice. 1

RealPresence Group Series backplanes and line drawings


RealPresence Group microphone array (MACO)


RealPresence Group remote control


• 6’ cable included‒ No way to extend it so the use case of

huddle/SOHO office is limited to that distance from the codec.

• FAQ attached

EagleEye Acoustic cameraAdobe Acrobat

Document


RealPresence Group 300/500 backplane

+12V

HDCI

1 HD

MI 1.3

2 HD

MI 1.3

2 COMHD

MI 1.3 VGA

1

Mini-DIN8 pin

+12V

HDCI

1 HD

MI 1.3

2 HD

MI 1.3

COM1

Mini-DIN8 pin

HDCI camera inputSupports audio from EagleEye Acoustic

YPbPr & TDMS digital

HDMI video and audioTDMS digital / VGA

video #2 input

3.5mm

audio inputLine level

CLink 2 audio input2 devices maximum

Monitor #1 output

HDMI w/ audio or DVI

Main audio output3.5mm

Monitor #2 output

HDMI or DVI

2 USB 2.1Serial

interface8-pin DIN

1G LAN

Power Supply input

RealPresence Group 300

RealPresence Group 500

IR receiver in front of case and on HDCI input


RealPresence Group 300 Dimensions


RealPresence Group 500 Dimensions


RealPresence Group 300/500 Power supply


RealPresence Group 700 backplane

HDMI inputWith audio

3.5mm audio inputLine level

Associated with input #3

HDCI input Supports audio from EagleEye Acoustic

YPbPr & TDMS digitalInput #2 also supports VGA

VGA inputMonitor outputs #1-3

3 is content onlyHDMI with AudioYPbPr or RGB

Power interface

2 x CLink 2Total of 3 devices

Not active

Serial interface (DB9f)

Grounding connection

2 * USB 3.0

1Gig LANHost & Slave

Video inputComposite or Component

Audio input Stereo RCA

line level

Audio outputStereo RCA

line level

Audio input Stereo RCA

line levelAssociated with

input 4

At 1st release USB will not be active

IR receiver in front of case and on HDCI inputs #1 & 2


• Notes:

1. Retained Power State is ‘ON’ if the A/C power was previously removed when the codec was NOT in the “OFF State”. Otherwise, Retained Power State is ‘OFF’.

2. Codec Option allows the IR Remote’s Hang‐Up Button to be set for ‘Off’, or ‘Sleep’ functions

3. Codec Option allows the Monitors to drive ‘Black’ or ‘No Signal’ when in the ‘Sleep State’

4. Codec Option to set elapsed time before entering ‘Sleep State’

5. Camera’s IR detector is only active when the camera is powered either by codec, or w/ external adapter

RealPresence Group 700 power states


RealPresence Group 700 line drawing


EagleEye IV standard configuration


EagleEye IV wide angle lens configuration

© Polycom, Inc. All rights reserved. 14

EagleEye IV camera Options• RealPresence Group Series bundles shipping

‒ Korea and Russia now due 7/1/2014, dependent on regulatory approvals.

• Standalone EagleEye IV camera‒ 12x (8200-64350-001)

‒ 4x (8200-64370-001)

• Cables, shipping schedule follows bundles:‒ HDCI on the codec side, mini-HDCI on the camera side, see photo

‒ 3m cable, standard ships with all EagleEye IV cameras – (2457-64356-001)

‒ 1m cable – (2457-64356-100)

• EagleEye Digital Extender – (2215-64200-001)• Wide angle lens – (for 4x 2200-64390-002, for 12x 2200-64390-001)

‒ This lens causes artifacts at the edges when zoomed all the way out. Thus priced low

• ‘Eye Patch’ for secure installations – (2215-28454-002)• Mounting shelf – (2215-24143-001, current shelf)

‒ Update will be forth coming to allow the EagleEye IV to be mounted in all configurations, and include consideration for mounting the EagleEye Digital Extender


• Polycom branded adaptor will allow EagleEye IV (4x & 12x) to connect via HDCI

• Adaptor boosts signal allowing camera to be extended over CAT 6a to lengths up to 100m / 330 ft (1080p), cat 5e for shorter runs to be accepted− Loops limited, see installation guides− Solid conductor cable, not stranded/patch cord

• Flexibility for integrators

• Ease of ordering for customers− Power cord ordered separately or provided by customer

• Based on HDBaseT technology− Additional information on HD BaseT

Polycom EagleEye Digital Extender

Cat 6a up to 100m

Not to scale

http://en.wikipedia.org/wiki/HDBaseT




Cable detail for EagleEye Digital Extender

• Polycom strongly recommend customer to use high quality Shielded, solid conductor CAT6A variety (F/UTP) cable or a

qualified HDBaseT cable(http://www.hdbaset.org/cables) for optimal performance. • Use the shortest patch cable that is reasonable – don’t use a 5 meter when you only need a 1 or 2 meter. This

minimizes the amount of extra wire to dress properly• On excess cable – do not coil it up or bowtie it. Let it drape and/or run straight and make gentle bends when appropriate• Minimize coupling to other cables (even itself). Want to avoid laying it next to AC cords, other Ethernet Cords, HDMI, etc.

(This is where shielded CAT6A could be used without this being an issue).• Avoid using zip ties to bundle or secure the cable in anyway – especially CAT 6A. Use Velcro ties when necessary.• Indicate that solid wire is preferred for any distance beyond 10 meters (that is total distance) Stranded wire (except for

short patch cables) must be avoided. Even for patch cables, solid wire would be better.

http://www.hdbaset.org/cables


EagleEye Digital Extender line drawing


2215-65169-001: Mounting bracket for RealPresence Group 300 & 500. Allows EagleEye camera and codec to be mounted together. Recommends use of 2215-24143-001 mounting bracket for wall/display mounting.

RealPresence Group 300/500 mounting hardware


• 2215-06177-001

• LDSC: Shelf for mounting the RealPresence Group 300 & 500 series codecs. This is a black 1u shelf for 19" racks which will hold the codec in position with a secure mounting system. 1u (1.75 inches) x 17.5” (without ears, 19” with) x 9.8” deep. Shelf only.

1u mounting shelf for the RealPresence Group 300/500 codecs


• U or Sandwich mounting‒ 2215-65169-001, current price list

• 1u shelf ‒ 2215-06177-001, September price list

• Retrofit “L” bracket for CP options‒ Only as part of a CP solution, for converting existing HDX Media

Center and HDX Executive Collection to use a RealPresence Group Series codec

• 3RD party behind the monitor mount‒ KCG POLYCOM GROUP SERIES MOUNT

‒ [email protected], 717.549.3600

• Updated StereoSurround kit‒ Universal subwoofer update for WW energy requirements, one sub

with 2 different fuses (120v or 240v)

‒ 2200-65878-001, August price list

RealPresence Group Series mounting solutions

mailto:[email protected]


42” RealPresence Group Series Media Centers

Available only as dual screen



Available as single & dual screen





Dual does not support mobility – casters.



Available as single and dual screen

These dimensions only for single screen. Dual screen uses 2 of these side-by-side, 2nd does not have a camera. Camera can be mounted above either of them, but with the codec.


Lower Camera Mount (LCM) viewing heights

With casters

With slides


See this web link for DXF and PDF of all the Group Video products:

http://planetpolycom/sites/sales/VSG/VSG%20Dimensional%20Drawings/Forms/AllItems.aspx




Date post:	28-Nov-2014
Category:	Technology
Upload:	mohamed-el-behery
View:	502 times
Download:	1 times

polycom , group series, setup, hardware

Technology