1
GOLDEN RULES FOR SUCCESSFUL INSTALLATION 4 1 2 1 3 H = 65 cm H = 50 cm H = 40 cm 4° 10° 10° 10° +15% -15% 10° 4° 0° 0° / 4° / 10° 1 1 1 2 2 2 3 3 3 A B C 1 1 1 2 2 2 3 3 3 A B C 1 1 1 2 2 2 3 3 3 A B C 1 1 1 2 2 2 3 3 3 A B C 1 1 1 2 2 2 3 3 3 A B C 1 1 1 2 2 2 3 3 3 A B C 1 1 1 2 2 2 3 3 3 A B C 1 1 1 2 2 2 3 3 3 A B C High sensitivity Front system Rear system 20 s STOP 50 cm 8 s (default setting) (default setting) STOP 30 cm (default setting) Low sensitivity 1 1 1 2 2 2 3 3 3 A B C 1 1 1 2 2 2 3 3 3 A B C Jumper m in > 5 s > 5 s Min Max X4 5s Min > 5 s > 5 s Max or < 0.9 m 1.5 m FRONT MODE REAR MODE SET UP SENSORS ON THE BUMPER (FRONT/ REAR) SETTINGS SET UP THE JUMPER ON ECU (FRONT/REAR MODE - TOW BAR OFF-SET - SENSITIVITY) 3 SET UP THE LCD DISPLAY 2 SET UP THE LOUDSPEAKER 4 FUNCTIONAL TEST FIT THE ANGLE RINGS 5 WIRING CHOOSE THE CORRECT ANGLE RINGS 4- SENSORS A B C D A B C D Sensor Sensor cable 2A Mute control (Yellow) GND Brake light (white/red) Reversing light (white) ACC( +12V ) pink 1 2 3 4 DCBA A B C D Sensor LED display is optional (P/N 632215) Sensor cable DCBA A B C D 2A Mute control (Yellow) GND Brake light (white/red) Reversing light (white) ACC( +12V ) pink 1 2 3 4 2 WIRING DIAGRAM 1 POWER WIRING FOR REAR AND FRONT A = 1/8 L = 22 cm max A A A A 2A 2A Ø 3 mm Ø 18,8 mm FRONT MODE Reverse light 1/ Ground: black 2/ Brake light: white with red stripes 3/ + Reverse: white 4/ +ACC: Pink 1 2 3 4 Brake light Optional Connection to trailer plug (See section page 55) Reverse light 1/ Ground: black 2/ Auto trailer detection: white with red stripes 3/ + Reverse: white 4/ +ACC: Pink 1 2 3 4 REAR MODE H H 90+/-5° 90+/-5° RECOMMENDED TOOLS : Ø 3 mm UK TECHNICAL HOTLINE : 01527 516 910 THIS DOCUMENT DOES NOT REPLACE THE FITTING INSTRUCTION MANUAL PROVIDED WITH THE KIT, WHICH SHOULD ALWAYS BE CONSULTED PRIOR TO INSTALLATION
