Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com

rev.020620

SWRFD-60ERadio Replacement with Steering Wheel Control Retention

for Select Ford Vehicles with 4” Screen

1 of 5

RADIO REPLACEMENTSWC RETENTION

+R

INTERFACING SOLUTIONS

- Retains factory features in select Ford vehicles with 4” screen.- Pre-programmed to retain factory Steering Wheel Controls.- Retains factory 4” screen.- Works on vehicles with or without Sync.- Retains factory Aux-Input on vehicles without Sync.- Retains voice command features on vehicles with Sync.- Phone pick up and hang up functions using the steering wheel control buttons.

PRODUCT FEATURES:

PARTS INCLUDED:

INSTALLATION DIAGRAM:

CAN Module SWC Module SWRFD-60E Harness SWC Cable

AFTERMARKETRADIO

+12V Constant Yellow+12V ACC Red

12V Ground BlackIllumination Orange

Reverse Gear Purple/WhitePower Antenna Blue/White

Vehicle Speed Sense PinkRight Front (+) GrayRight Front (-) Gray/BlackLeft Front (+) WhiteLeft Front (-) White/Black

Right Rear (+) VioletRight Rear (-) Violet/BlackLeft Rear (+) GreenLeft Rear (-) Green/Black

Factory Aux Input*

24-PinPlug

TO FACTORYRADIO

HARNESS

12-PinConnector

SWCMODULE

ON

RA

DIO

VEH

ICLE

1 2

3 4

5 6

7 8

AFTERMARKETRADIO SELECTOR

(See Chart)

FORDSWC SETTING

(OFF OFF OFF OFF)

ON RADIO VEHICLE

1 2 3 4 5 6 7 8

Cap or insulate ifnot being used

Kenwood/JVC (BLUE / YELLOW)

Insulate with tapeif not being used

3.5MM SWC CABLEPlug in the 3.5MM SWC cable to the 4-pin porton the module. See “DIP SWITCH SETTINGS” section.

12-PinConnector

TO FACTORYSCREEN

TO FACTORYSCREEN

HARNESS

SWC 1with Sync(Orange wire) SWC 2

without Sync(Blue wire)

* Retention of factory AUX Input is available ONLY on vehicles WITHOUT Sync.

CANMODULE

Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com

rev.0206202 of 5

RADIO REPLACEMENTSWC RETENTION

+R

INTERFACING SOLUTIONS

SWRFD-60ERadio Replacement with Steering Wheel Control Retention

for Select Ford Vehicles with 4” Screen

DIP SWITCH SETTINGS:

FORD STEERING WHEEL CONTROL DIP SWITCH SETTING:

AFTERMARKET RADIO DIP SWITCH SETTINGS:

RADIO BRAND: DIP: 1 2 3 4

Atoto, Dual, Farenheit, Jensen, PioneerPower Acoustik, SoundstreamBlaupunkt, Most o�-brand Radios AlpineClarionKenwoodJVCBoss, Old SonyNew Sony

OFF OFF ON ONOFF OFF ON ONOFF OFF ON ONOFF OFF OFF OFFOFF ON ON OFFOFF ON ON ONOFF ON OFF ONOFF ON OFF OFFOFF OFF ON OFF

SWC MODULE

ON RADIO VEHICLE

1 2 3 4 5 6 7 8

NOTE: For Atoto, Blaupunkt, Dual, Farenheit, Power Acoustik, Soundstream, and most o�-brand radios, check the aftermarket radio’s manual to see if the SWC buttons need to be programmed.

DIP: 5 6 7 8

Ford OFF OFF OFF OFF

SWC MODULEON RADIO VEHICLE

1 2 3 4 5 6 7 8

1. The factory AUX Input is retained ONLY on vehicles without Sync system.2. The Date and Time display MUST BE adjusted prior to removal of the factory radio. You cannot make adjustments once the

radio has been removed.3. The SWRFD-60E does not retain Sync features.

NOTE: Insulate the Blue/Yellow wire or 3.5mm plug if not being used.

3.5MM SWC CABLE Plug in the 3.5MM to 4-Pin SWC cable to the SWC module.

NOTES:

IMPORTANT INSTALLATION NOTES:

Plug the 12-pin Molex connector labeled “To CAN Module” to the CAN module

Plug the 12-pin Molex connector labeled “To SWC Module”to the smaller SWC Module

Failure to do so will damage the modules!

RED to SWC Key 1WHITE to SWC Key 2SHIELD to SWC Ground

For aftermarket radios that have wires for SWC connections, cut off the 3.5mm plug on the Crux SWC Cable and connect the SWC wires as follows:Note that there are some radios that only have SWC1 and SWC2, in this case “shield” does not need to be connected.

Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com

rev.0206203 of 5

RADIO REPLACEMENTSWC RETENTION

+R

INTERFACING SOLUTIONS

SWRFD-60ERadio Replacement with Steering Wheel Control Retention

for Select Ford Vehicles with 4” Screen

IMPORTANT:

Set time and date before removing the factory radio. Go to Menu > Clock Settings > Set Time / Set Date.

1. Carefully remove the top cover of the screen.

2. Remove the rubber mat on top of the dashboard.

3. Remove the 2 screws under the rubber mat.

4. Pop up the top portion of the dashboard.

5. Remove the 2 screws holding the radio faceplate.

6. Remove the radio faceplate and unplug the connector.

INSTALLATION INSTRUCTIONS:

Connect the SWRFD-60E T-harness to the aftermarket radio harness. Refer to the diagram on page 1 for wire color codes.

Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com

rev.0206204 of 5

RADIO REPLACEMENTSWC RETENTION

+R

INTERFACING SOLUTIONS

SWRFD-60ERadio Replacement with Steering Wheel Control Retention

for Select Ford Vehicles with 4” Screen

OPERATION:

Bluetooth handsfree steering wheel controls:

7. Remove the 2 screws holding the headunit.

8. Unplug the headunit connectors. 9. Mate the headunit connectors to the SWRFD-60E T-harness connectors.

The 4” screen needs to be removed to plug in the SWRFD-60E factory screen retention harness. Unplug the factory 12 pin connector from behind the screen and plug it into the 12 pin male connector of the SWRFD-60E harness. Plug the 12 pin male connector of the SWRFD-60E harness to the screen.

For vehicles with Sync, long press of factory pick up and hang up buttons on SWC is retained.

For vehicles without Sync, long press of = pick up, long press of = hang up.

For vehicles with Sync, short press of CMD = Voice Command Activate / Deactivate

VEHICLE APPLICATIONS:

Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com

rev.0206205 of 5

RADIO REPLACEMENTSWC RETENTION

+R

INTERFACING SOLUTIONS

SWRFD-60ERadio Replacement with Steering Wheel Control Retention

for Select Ford Vehicles with 4” Screen

FORD2011 - 20142013 - Up2011 - 20152013 - 20142014 - Up2012 - 20142015 - Up2014 - 2018

EdgeEscapeExplorerF-150FiestaFocusTransitTransit Connect

2013 Escape 2015 Transit Connect

2014 F-150 2014 Focus

SYSTEM COMPATIBILITY:

4” screen with or without MyFord Touch (Sync)