+ All Categories
Home > Documents > Projects & Solutions Mini Guide - Freeman Sea Cock

Projects & Solutions Mini Guide - Freeman Sea Cock

Date post: 25-Jul-2016
Category:
Upload: sheridan-marine
View: 218 times
Download: 0 times
Share this document with a friend
Description:
A series of FREE Mini Guides for boating projects that run through the basic steps for the practical boat owner. This Mini Guide concentrates on general inspection & maintenance of the most common Freeman Sea Cock, the engine water cooling inlet, and the break down of parts likely to be found.
2
Projects & Solutions SHERIDAN MARINE By River, By Road, By Mail... Order the Solutions 01491 652 085 Freeman Sea Cock Sea Cock Cap The Sea Cock Cap prevents water entering the boat but allows access to the filter. Should water in the sea cock freeze the cap top may ‘bulge’ slightly or even crack. If the cap has bulged into a ‘dome’ or has signs of wear, it should be replaced. New Sea Cock Cap GV070 Cap Washer Replace the Cork Washer in the cap regularly, this helps create a watertight seal when the sea cock cap is tightened. Sea Cock Filters Sea Cock Filters remove unwanted debris from the river water that is used in the engine cooling system. Cleaning regularly is essential and if worn or damaged, a new filter should be installed. Freeman Sea Cock Filters Cork Washer GV071 Most common Freeman Sea Cock setup. Domed cap due to freezing.
Transcript

Projects &

Solutions SHERIDAN MARINEBy River, By Road, By Mail...

Order the Solutions

01491 652 085

Freeman Sea Cock Sea Cock CapThe Sea Cock Cap prevents water entering the boat but allows access to the filter. Should water in the sea cock freeze the cap top may ‘bulge’ slightly or even crack. If the cap has bulged into a ‘dome’ or has signs of wear, it should be replaced.

New Sea Cock Cap GV070

Cap WasherReplace the Cork Washer in the cap regularly, this helps create a watertight seal when the sea cock cap is tightened.

Sea Cock FiltersSea Cock Filters remove unwanted debris from the river water that is used in the engine cooling system. Cleaning regularly is essential and if worn or damaged, a new filter should be installed.

Freeman Sea Cock

Filters

Cork Washer GV071

Most common Freeman Sea Cock setup.

Domed cap

due to freezing.

Projects &

Solutions SHERIDAN MARINEBy River, By Road, By Mail...

Order the Solutions

01491 652 085

Freeman Sea CockThe Gate ValveThis should be capable of stopping water flow when required. Common wear points are the handle and the shaft. Once the Gate Valve fails to work consider replacing immediately.

AccessoriesAdditional useful equipment for the Freeman Sea Cock.

Mastic Tape

Water StrainerCheck that the hull Water Strainer is clear. Young Mussels can enter, grow & become stuck, blocking water flow. This is the first line of engine cooling water filtration so it is good practice to keep this clear.

Bilge Cleaner

Bilge Paint

New Water

Scoops

© Sheridan Marine 2016. All rights reserved. E&OE. This is a project guidance sheet and not a ‘How-to’ fact book. It is presumed that all work is carried out safely following the product man-ufacturers instructions. Each project may differ so may need further discussions and guidance.

Sea Cock Gate Valve

New Water Strainers


Recommended