Date post: | 06-Jan-2018 |
Category: |
Documents |
Upload: | candice-dean |
View: | 217 times |
Download: | 0 times |
Prostorquer working instructions
Transferring prosthetic parts easily and safely with one hand
Omplant Ltd.
1
Press OUT to catch each one of the healing caps
Omplant Ltd.
2
Press IN one second to load the healing caps orderly into the organizer
Omplant Ltd.
3
Locate the abutment holder exactly on abutment shoulder*If you are using other than omplant’s abutment the holder is not useful ,so use the driver
only to the abutment’s screw.
Omplant Ltd.
4
Connect the driver *gently from angled position note: bit is still outside screw hex
*match bit length to shoulder height
Omplant Ltd.
Omplant Ltd.5
Press IN to let the bit enter into screw hex .Stop with click sound.
6
Press OUT to open the abutment screw
Omplant Ltd.
7
Take the abutment “as is” to the implant
Omplant Ltd.
8
Press IN only after an abutment is set inside the internal hex, Stop with click sound
Omplant Ltd.
check cast /porcelain on abutments ,use the same manner 3-8 to transit the abutments back to analogues
When finished, disconnect the holder Omplant Ltd.
9
Press OUT to catch the healing caps from the organizer
Omplant Ltd.
10
Press IN to connect the healing caps back to implants. Stop with click sound.
Omplant Ltd.