Date post: | 24-Dec-2015 |
Category: |
Documents |
Upload: | brice-davidson |
View: | 213 times |
Download: | 0 times |
PVSS Installation of a Project
Need to run this by Xiaofeng to make sure the steps are right
Assumes PVSS installed
• Current patch shouldn’t be later than July 08, because there were problems with the DB since then. I don’t use the DB, so it doesn’t matter much, but…
Get Framework
• Install framework in PVSS as specified• Get fwInstallation package and save• Use a separate directory from the ETM tree
Unpack your project into a folder
Run PVSS, request new project
Standard is OK
Tell it the project name
Browse for the folder
Create new folder
Project Name doesn’t have to be the same as the folder name
General Settings are OK
Wait for a few minutes
And acknowledge the OK
New Project appears
Unpack fwInstallation package:
Next slide
into subfolder of project
Start Project
You click on the projectPut the mouse over the “start project” iconClick when the icon turns green (a few seconds)
Next
• Log Viewer, Gedi, and PVSS Console appear• In Gedi, start the Installer as shown in the next
slide
Gedi
From subfolder fwInstallation
fwInstallation.pnl
SOME Framework versions!
Asks for a directory to install in: invents a name. OK
SOME Framework versions!
Wants a DB connection. I DON’T USE THIS: NO
Framework Installation Panel
Browse for folder
Select folder
Select Components
Click on components you need
Then click Install
Select installation directory
Suggested is OK
Click OK
Click Install again onFramework Installation Panel!
• I don’t know why• Some Framework versions only
Click OK for installation
Project will have to restart
This takes a few minutes
Windows will complain
Make sure you unblock everything it complains about. I use DIM, and Windows firewall wants to make sure that’s all right with me.
Now run the fwInstallation Panel again
• See previous slides– Gedi– fwInstallation– fwInstallation.pnl
Install your project
Select Install
Click Install at the bottom of the list
OK to verification panel
Project will have to restart
This takes a few minutes
Fiddle with your new project as needed
In my case I need to change the DIM DNS server