The Trusted Source ® Quadratec ® Vehicle Cover Installation & Care for Jeep Wrangler Vehicle Covers # 11081.02XX These Covers are not machine-washable. Shake cover to remove dust, hose it off to remove dirt, and spot clean using a mild soap and water. In high winds, ensure cover is securely tied down using the loops, cord and the cable security kit. In severe conditions, ad- ditional tie-down cords may be required. Store cover in the provided storage bag. Ensure cover is dry before placing in bag In freezing weather the cover may freeze to the vehicle. Ensure ice has thawed be- fore attempting to remove the cover. Do not drive or tow the vehicle with the cover in place. Do not use on a recently painted vehicle. Allow new paint to cure for 6 months before using a car cover. Do not install the cover over hot surfaces, including exhaust pipes. Should you need to mark the cover with a license plate number or similar identifi- cation, use only fabric paint, available at most craft stores. Do not use regular paints or permanent markers. Removal of the radio antenna before in- stallation of the cover is strongly recom- mended. However, if you do not want to remove your antenna on a regular basis a provided grommet can be installed. Keep in mind that this will adversely affect the cover’s ability to keep out water in this area. Remove the antenna and fully install the car cover taking special care that it is aligned evenly over the vehicle. Locate and mark the location of the base of the antenna with a pencil. Remove the car cover. Carefully cut a ½ inch “X” over the mark you made in the cover. Align the top and bottom halves of the grommet on either side of the “x” hole in the cover and rest them against a hard surface. Firmly press the two halves of the grommet together until they lock. It may be necessary to gently strike with a non- marring mallet in order to engage the two halves. For future use make sure the grommet is slid over the antenna first before installing the mirrors into the mirror pockets. Install the cover by unfolding or unrolling along the length of the vehicle. Fit the mirror pockets over the mirrors first, then carefully extend the cover to snugly fit over each end of the vehicle. Remove in the opposite order: loosen each end of the cover first, remove mirrors from the mirror pockets, then fold the cover back onto itself before folding or rolling the cover along the length of the vehicle.
Transcript
The Trusted Source
®
Quadratec® Vehicle CoverInstallation & Care for Jeep Wrangler Vehicle Covers #11081.02XX
These Covers are not machine-washable.Shake cover to remove dust, hose it off toremove dirt, and spot clean using a mildsoap and water.
In high winds, ensure cover is securelytied down using the loops, cord and thecable security kit. In severe conditions, ad-ditional tie-down cords may be required.
Store cover in the provided storage bag.Ensure cover is dry before placing in bag
In freezing weather the cover may freezeto the vehicle. Ensure ice has thawed be-fore attempting to remove the cover.
Do not drive or tow the vehicle with thecover in place. Do not use on a recentlypainted vehicle. Allow new paint to curefor 6 months before using a car cover.Do not install the cover over hot surfaces,including exhaust pipes.
Should you need to mark the cover witha license plate number or similar identifi-cation, use only fabric paint, available atmost craft stores. Do not use regularpaints or permanent markers.
Removal of the radio antenna before in-stallation of the cover is strongly recom-mended. However, if you do not want toremove your antenna on a regular basis aprovided grommet can be installed.
Keep in mind that this will adverselyaffect the cover’s ability to keep out waterin this area. Remove the antenna and fullyinstall the car cover taking special carethat it is aligned evenly over the vehicle.Locate and mark the location of the baseof the antenna with a pencil.
Remove the car cover. Carefully cut a ½inch “X” over the mark you made in thecover. Align the top and bottom halves ofthe grommet on either side of the “x” holein the cover and rest them against a hardsurface. Firmly press the two halves of thegrommet together until they lock. It maybe necessary to gently strike with a non-marring mallet in order to engage the twohalves.
For future use make sure the grommet isslid over the antenna first before installingthe mirrors into the mirror pockets.
Install the cover by unfolding or unrollingalong the length of the vehicle. Fit themirror pockets over the mirrors first, thencarefully extend the cover to snugly fitover each end of the vehicle.
Remove in the opposite order: loosen eachend of the cover first, remove mirrors fromthe mirror pockets, then fold the coverback onto itself before folding or rollingthe cover along the length of the vehicle.
Q_JEEP_CVR_UPDATE_A4.qxp_Layout 1 1/8/18 10:55 AM Page 1
The Trusted Source
®
Quadratec® ExclusiveOne Year Limited Warranty
Your Quadratec® branded accessories arecovered by the following Limited Warrantyprovided exclusively by Quadratec, Inc., 1028Saunders Lane, West Chester PA 19380.
This Limited Warranty is the only warranty madein connection with your purchase. Quadratec nei-ther assumes nor authorizes any vendor, retaileror other person or entity to assume for it anyother obligation or liability in connection withthis product or Limited Warranty. This LimitedWarranty does not apply and is not cumulative toany accessory or part distributed by Quadratecfor which the Manufacturer provides a separatewritten warranty.
What is Covered: Subject to the terms, exclusionsand limitations herein and with respect only toQuadratec branded accessories first sold in theUnited States, Quadratec warrants to the initialretail purchaser only that your Quadratec acces-sory shall be free of defects in material and work-manship: for a period of one (1) year from date ofretail purchase.
This Limited Warranty is not assignable and shallterminate upon sale of the vehicle upon which theQuadratec accessory is installed or other transferthird persons.
All other warranties are hereby disclaimed, exceptto the extent prohibited by applicable law inwhich case any implied warranty of mer-chantability or fitness for a particular purpose onthis product is limited to 1 year from date of ini-tial retail sale. Quadratec reserves the rights to:(a.) require invoice or other proof your accessoryis within the terms of this Limited Warranty as acondition of warranty service and, (b.) makefuture revisions to this product and LimitedWarrantywithout prior notice or obligation toupgrade your product.
What is Not Covered:Your Quadratec Limited Warranty does not coverproducts or parts Quadratec determines to havebeen damaged by or subjected to:
(a.) installation damage, alteration, modification,combination with other parts, failure to maintainor improper repair or service, (b.) normal wear &tear, cosmetic damage or damage from moistureor water immersion, (c.) Acts of God, accidents,misuse, negligence, inadequate mounting orimpact with vehicle(s), obstacles or other aspectsof the environment, (d.) theft, vandalism or otherintentional damage.
Remedy Limited to Repair/Replacement:The exclusive remedy provided hereunder shall,upon Quadratec inspection and at Quadratec’soption, be either repair or replacement of productor parts (new or refurbished) covered under thisLimited Warranty. Customers requestingwarranty consideration should first contactQuadratec to obtain a RGA number(610-701-3336). All labor, removal, shippingand installation costs are customer’s responsibility.
Other Limitations - Exclusion of Damages - YourRights Under State Law:In consideration of the purchase price paid, nei-ther Quadratec nor any independent Quadratec distributor/licensee are responsible for any timeloss, rental costs, or for any incidental, conse-quential, punitive or other damages you mayhave or incur in connection with any part orproduct purchased. Your exclusive remedyhereunder for covered parts is repair/replacementas described above.
This Limited Warranty gives you specific rights.You may also have other rights that vary fromstate to state. For example, some states do notallow limitations of how long an implied war-ranty lasts and /or do not allow the exclusion orlimitation of incidental or consequential damages,so the limitations and exclusions herein may notapply to you.
