[email protected]@j-drain.com www.j-drain.com
BRO-LD-SWD-0416
REMOVING STANDING WATER IN YARDS AND LANDSCAPE THE EASY WAY!
J•DRAIN SWD is an effective method for removing standing water in manylandscape applications without disrupting the surrounding areas by placing SWD in narrow trenches and backfilling with sand.
APPLICATIONS: LAWNS, GARDENS, PLAYGROUNDS, ATHLETIC FIELDS,GOLF COURSES, SYNTHETIC TURFS, HORSE FARMS, AND LANDSCAPE.
Site Water Drainage
SWD
292 S. Main St., Suite 200 Alpharetta, GA 30009
(800) 843-7569 (770) 442-1461Enterprises, Inc.
2 - 3 INCH MIN. WIDTH
J•DRAIN SWD-6
SAND BACKFILL PROVIDESRAPID DRAINAGE OFSURFACE FLOW, FLOWTHROUGH TURF AND FLOWTHROUGH ROOT ZONE
SURFACE FLOW
FLOW THROUGH TURF
FLOW THROUGH ROOT ZONEPROMOTES HEALTHY TURF
TRENCH DEPTH MIN. 12" TO PROVIDEDRAINAGE OF ROOT ZONE
LOCATE AND DIG TRENCHES
T-CONNECTOR DETAIL END CONVERSION TO PIPE
SPLICING DETAIL END CAP FITTING INSTALLING INTO TRENCH
TEMP. STAKES FOR CENTERING INSTALLING SAND BACKFILL
INSTALL AND TAPE FITTINGS
ENDOUT T CONNECTOR
SPLICE END CAP (6” only)
Site Water Drainage
SWD
SYNTHETIC TURFINSTALLATIONS:
J•DRAIN SWD-12 FOR LATERAL DRAINAGE DRAINAGE LATERALS INTO SIDELINE TRENCH FINISHED PLAYING FIELD
VERY COST EFFECTIVE: ELIMINATES ALL TRENCHES ACROSS FIELD WHILE SPEEDING UP CONSTRUCTION TIME AND REDUCING INSTALLATION COST.
PLAYGROUNDINSTALLATIONS:
VERY COST EFFECTIVE: ELIMINATES ALL TRENCHES UNDER PLAYGROUND AND PROVIDES RAPID DRAINAGE, SAVING CONSTRUCTION TIME AND MONEY.
GOLF COURSEINSTALLATIONS:
INSTALLING J•DRAIN / FITTINGS BACK FILLING WITH SANDTRENCHING ACROSS FAIRWAY
NATURAL TURFINSTALLATIONS:
VERY COST EFFECTIVE: NARROW, SHALLOW TRENCHES CAN BE LAID FOR A FRACTION OF THE COST OF PIPE AND GRAVEL FILLED TRENCHES. LESS INTRUSIVE TO PLAYING AREA.
TRENCHING ACROSS FIELD
HORSE FARMINSTALLATIONS:
VERY COST EFFECTIVE: NARROW, SHALLOW TRENCHES CAN BE LAID FOR A FRACTION OF THE COST OF PIPE AND GRAVEL FILLED TRENCHES. SURFACE DRYING TIME GREATLY REDUCED.
TRENCHING AND INSTALLING J•DRAIN
J•DRAIN SWD-6 IN TRENCH / SAND BACK FILL J•DRAIN SWD-6 WITH ACCESSORIES
INSTALLING J•DRAIN SWD ACROSS PLAYGROUND FREE DRAINAGE PLAYGROUND
VERY COST EFFECTIVE: NARROW, SHALLOW TRENCHES CAN BE LAID FOR A FRACTION OF THE COST OF PIPE AND GRAVEL FILLED TRENCHES. CAN BE INSTALLED QUICKLY WITH LESS DAMAGE TO AREA.
[email protected]@j-drain.com www.j-drain.com
292 S. Main St., Suite 200 Alpharetta, GA 30009
(800) 843-7569 (770) 442-1461Enterprises, Inc.
INSTALLATION PROCEDURE:1. Determine drainage layout. Mark field or drainage area with a chalk line at trench locations.
2. Excavate trenches 2” - 3” (33 - 105 mm.) wide and to a depth so that the top of the J•DRAIN SWD is 6” below the turf surface.
3. Unroll and place J•DRAIN SWD into trench centering with temporary wood stakes. Install proper fittings and tape fittings in place. Use a select backfill such as washed concrete sand.4. Remove temporary stakes and flood trench with water to promote proper compaction.5. Top off trench with sand and replace sod.
TYPICAL GRIDIRON PATTERN FOR TEE BOXES, FAIRWAYS, LAWNS AND GREENS
RANDOM PATTERN FOR SAND TRAPS, FAIRWAYS AND LAWNS
TYPICAL HERRINGBONE PATTERN FOR GREENS, FAIRWAYS AND LAWNS
TO OUTLET
TO OUTLET
TO OUTLET
SL
OP
E SAND TRAPSFAIRWAYSLAWNS
SLOPE
SLOPE
TYPICAL DRAINAGE LAYOUTS FOR J•DRAIN SWD
EN
DZ
ON
E6 IN. COLLECTOR PIPE
1 %
SLO
PE
45°
J•DRAIN SWD-6 or SWD-12
CROWN
1 % SLOPE TO DISCHARGE
EN
DZ
ON
E
6 IN.
SLO
PE
SLO
PE
COLLECTOR PIPE
1 % SLOPE TO DISCHARGE
TYPICAL ATHLETIC FIELD DRAINAGE LAYOUT
1 % SLO
PE
J•DRAIN SWD-6
12”MIN.
2”-3”WIDTH
SAND BACK FILL
TYPICAL NATURAL TURF DETAIL
TYPICAL SYNTHETIC TURF DETAIL
J•DRAIN SWD-12
GRAVEL
TURF AND PAD
NOTE: J•DRAIN SWD-6is placed verticallyin narrow trenchesand sloped to sidelines. Narrowtrenches are lessintrusive to playingfield.
NOTE: J•DRAIN SWD-12is placed horizontallyacross playing fieldand sloped to sidelinetrenches thuseliminating crossfieldtrenching.
The information contained herein is believed by JDR Enterprises, Inc. to be accurate and is offered solely for the customer’s consideration, investigation and verification. Determination of suitability for use is the responsibility of the user. JDR’s Limitiations, Limited Warranty, & Disclaimer along with Standard Terms & Conditions apply. See www.j-drain.com for more info. Limitations: J-DRain is resistant to chemicals in normal soil environments. However, some reagents may affect the performance of J-DRain. A JDR representative should be contacted for further information to determine the suitability of use of J-DRain in unusual soil environments. J-DRain should be limited to its exposure to ultra-violet sunlight. J-DRain should be backfilled or covered within seven days of installation. Disclaimer: All information, drawings and specifications are based on the latest published information at the time of printing. JDR reserves the right to make changes due to manufacturing improvements and engineering at any time. All physical properties are minimum average roll values (MARV). Standard variations of 10% in mechanical properties and 15% in hydraulic properties are normal.
BRO-LD-SWD-0416
Fabric2 2Flow (ASTM D-4491) 140 gpm/ft (5704 lpm/m )
CBR Puncture (ASTM D-6241) 250 lbs. (1.11 kN)
AOS (ASTM D-4751) 70 U.S. Sieve (.212 mm)
Grab Tensile (ASTM D-4632) 100 lbs. (.45 kN)-1Permittivity (ASTM D-4491) 2.0 sec
U.V. Resistance (ASTM D-4355) 70% @500 hrs.
Core
Roll Weight: 38, 68, 83, 98, & 128 lbs. (17, 30, 37, 44, & 57 kgs.)Roll Width: 6”, 12”, 18”, 24”, & 36” (15, 30, 38, 45, & 60 cm.) Roll Length: 165 ft. / 300 ft. (50.29 / 91.44 meters)
2Compressive Strength (ASTMD-1621) 9,500 psf (455 kN/m )
Thickness (ASTM-1777) 1 In. (2.54 cm.)In-Plane Flow (ASTMD-4716) 30 gpm/ft width (372 lpm/m) (Q&518 psf & Hydraulic gradient = .1)
Rol
l
Physical Properties
Site Water DrainageSWD