TDR - ROTISSERIE OVEN MODELS TDW - WARMER MODELS• TDW 5 - Warming cabinet 25 to 30 chickens. •...

USAWWW.FRIJADO.COM Installation Manual TDR5/8 TDW 5/8 form 9123904 rev. 02/2014

INSTALLATION MANUAL

- NOTICE -This manual is prepared for the use of trained Service Technicians and should not be used by those not properly qualified. If you have atten-

ded a training for this product, you may be qualified to perform all the procedures in this manual.

This manual is not intended to be all encompassing. If you have not attended training for this product, you should read, in its entirety, the repair procedure you wish to perform to determine if you have the ne-cessary tools, instruments and skills required to perform the procedure. Procedures for which you do not have the necessary tools, instruments

and skills should be performed by a trained technician.

Reproduction or other use of this Manual, without the express written consent of Fri-Jado, is prohibited.

TDR - ROTISSERIE OVEN MODELSTDW - WARMER MODELS

MODELS

TDR 5 MTDR 8 MTDW 5 MTDW 8 M

TDR 5 P eco

TDR 8 P eco

TDW 5 PTDW 8 P

Model TDR 5 M Model TDR 8 Peco

Installation Manual TDR5/8 TDW 5/8 form 9123904 rev. 02/2014

TABLE OF CONTENTS

Page 3 Installation Manual TDR5/8 TDW 5/8 form 9123904 rev. 02/2014

VersionsVersion Issue date

dd/mm/yy

Remarks

03/2012 01/03/2012 First release.02/2014 01/02/2014 TDR P and TDRW added.


Index .......................................................................................................................................................... 4

General technical data .............................................................................................................................. 5

Installation procedures ............................................................................................................................. 6Unpacking the unit ................................................................................................................................ 6Location .................................................................................................................................................. 7Electrical supply ..................................................................................................................................... 8Legs / Castors .......................................................................................................................................... 9Tethering of the unit ............................................................................................................................. 9Test run ................................................................................................................................................. 10Heat extraction of the rotisserie ......................................................................................................... 10Instructions for operators .................................................................................................................... 10

Placing and connecting of the models .................................................................................................. 12TDR 5 M Pass Through ........................................................................................................................ 12TDR 5 P Pass Through .......................................................................................................................... 13TDR 8 M Pass Through ......................................................................................................................... 14TDR 8 P Pass Through .......................................................................................................................... 15TDR 5 + 5 M Pass Through ................................................................................................................... 16TDR 5 + 5 P Pass Through .................................................................................................................... 17TDR 8 + 8 M Pass Through ................................................................................................................... 18TDR 8 + 8 P Pass Through .................................................................................................................... 19TDRW 5 M Pass Through ..................................................................................................................... 20TDRW 5 P Pass Through ....................................................................................................................... 21TDRW 8 M Pass Through ..................................................................................................................... 22TDRW 8 P Pass Through ....................................................................................................................... 23TDR 5 M and TDR 5 P Pass Through on base ...................................................................................... 24TDR 8 M and TDR 8 P Pass Through on base ...................................................................................... 25TDW 5 M Pass Through ....................................................................................................................... 26TDW 5 P Pass Through ......................................................................................................................... 27TDW 8 M Pass Through ....................................................................................................................... 28TDW 8 P Pass Through ......................................................................................................................... 29

INDEX


GENERAL TECHNICAL DATA

GENERAL TECHNICAL DATA

This manual covers the TDR series rotisserie ovens and the TDW series warmers. Ovens and

warming cabinets come in two sizes. Ovens and warmers will also be delivered in stacked

versions.

• TDR5–Ovenwith5spits(15to20chickens)or5baskets(15chickens).

• TDR8-Ovenwith8spits(28to35chickens)or7baskets(28chickens).

• TDW5-Warmingcabinet25to30chickens.

• TDW8-Warmingcabinet35to40chickens.

Alloftheinformation,illustrationsandspecificationscontainedinthismanualarebasedon

thelatestproductinformationavailableatthetimeofprinting.

Type TDR 5 TDW 5 TDR 7 TDW 7

Power(W) 6600 2800 10500 3500

Fusesneededwithpowerconnec-tion208V,3~60Hz(3phaseswithoutzero)

3x20A _ 3x40A 3x20A

Fusesneededwithpowerconnec-tion208V,1N~60Hz(1phasewithzero)

_ 1x15A _ _

Standardplugfromfactory NEMA15-30P NEMA6-15P NEMA15-50P NEMA15-20P

Stackedcabinets:eachcabinetcomeswithseparatepowercord!!

Netweight(lbs) 287 220 408 331

Grossweight(lbs) 335 265 476 388

Height(inch) 353/4” 353/4” 413/4” 413/4”

Width(inch) 33” 33” 391/4” 391/4”

Depth(inch) 303/8” 303/8” 35” 35”

• Standardsetoftools.

• Metricwrenches,socketsandhexsocketkeywrenches.

• Multi-meterandACcurrentclampmeter.

• Temperaturetester.

• Insulationvaluetester(Megger).

• FieldServiceGroundingKit.

X

Y

GZ

G

X

Y

G

Z

XY

G

Z


INSTALLATION PROCEDURES


• Unpackingoftheunit.

• Removethepalletundertheunitwiththehelpofaforklift.

• Puttheunitonhislocation.

• Checkifthereisenoughfreespacearoundtheunit(seeinstallationdrawing).

• Checktheelectricalsupply.

• Tetheringoftheunit.

• TDR:Makeatestrunon482°F.

• TDW:Makeatestrunon210°F.

• Giveinstructionstotheoperator.

UNPACKING THE UNITImmediatelyafterunpackingtheoven,checkforpossibleshippingdamage.Iftheovenisfound

tobedamaged,savethepackagingmaterialandcontactthecarrierwithin15daysofdelivery.



LOCATION

Thestandardwaytoremovetherotisserieor

warmerfromapalletiswithaforklift.See

pictures.Opendoorandremovethedrawer.

Lifttheunitfrompalletandputtheunitin

itsplace.

Note: when lifting a stacked unit, always use

the drawer of the bottom unit.

Anotherpossibilityistodisassemblethepal-

let.ForthepalletoftheTDR8followthe

procedureonthephoto.

REMOVAL OF PALLET

Toavoidshort-circuiting,theunitsmaynotbe

usedoutdoors.Placingunderascreenisallo-

wed.

1 2 3

NL1

1 2 3

L2L1 L3

Page 8 Installation Manual TDR5/8 TDW 5/8 form 9123904 rev. 02/2014


Priortoinstallation,testtheelectricalservicetoassurethatitcorrespondswiththespecificati-

onsonthemachinedataplatelocatedontherightsidepanelnearthecontrols.Theconnecting

cablefortheunitmustbeequippedwithanapprovedplugconnection.Ifuseistobemadeofa

permanentconnection,theconnectingcablemustbeconnectedtoamanualon/offswitchthat

isinstalledneartheunitinaclearvisiblemanner.

ELECTRICAL SUPPLY

IMPORTANT: Makesureyoulea-vesufficientspacearoundtherotisserieorwarmertoeasilyremoveorinserttherotor.Ifthebasehas(rotating)wheels,theflooronwhichitrestsmustbelevel.

Theovenmustbeinstalledonalevelsurface.Theinstallationlocationmustallowadequate

clearancesforservicingandproperoperation.

Theconnectingcablefortheunitmustbeequippedwithanapprovedplugconnection.Ifuse

istobemadeofapermanentconnection,theconnectingcablemustbeconnectedtoamanual

on/offswitchthatisinstalledneartheunitinaclearvisiblemanner.

For a single-phase 208 V ~ circuit with neutral, the unit must be connected according to the figure below.

For a 3-phase 208 V ~ circuit without neutral, the unit must be connected according to the figure below.

208 V, 1N ~ 50...60 Hz208 V, 3 ~ 50...60 Hz



Eachovenandwarmerisfurnishedon115/16”legs.Stackedmodelsarefurnishedwith2swivel

and2lockingswivelcastors.Acastor-equippedstandwithconvenientstoragedrawerisavaila-

ble;theovenismountedontopofthestand.

LEGS / CASTORS

TETHERING OF THE UNIT

(FormodelTDR5andTDR8unitswhenstackedorplacedonbasewithcastors)

Warning:Safetystandardsrequirethat,whenthisapplianceisproperlyconnectedtotheelec-

tricalpowersupplyusingflexibleconduit,adequatemeansbeprovidedtolimitmovementof

theappliancewithoutdependingonortransmittingstresstotheelectricalconduit.Thismeans

that,aspartoftheinstallation,thebaseorbottomunitofstackedmodelsmustbesecuredto

thebuildingstructure(typicallyeitherwallorfloor)tolimitthemovementoftheappliance

and,thus,helpingtopreventdamagetotheconduitduringcleaning,maintenanceandservice

operations.

Atetherbracket,asshownonthedrawingbelow,isprovidedwiththebaseorstackingkit.

Basedontheroutingoftheflexibleconduit,thebracketmustbeinstalledalongwiththecaster

toonecornerofthebaseusingthehardwareprovided.Theremainingopenholeinthecenter

ofthetetherbracketistobeusedtosecureoneendofthetether(locallysuppliedchain,cable,

etc.).Theotherendofthetetheristobesecuredtoananchoringpointinthebuildingstruc-

ture.

Note: Length of tether must be shorter than the flexible conduit to make sure that during appli-

ance movement, no stress is transmitted to the conduit.

Warning:Followinginstallation,checktoconfirmthat,whentheapplianceismovedtothe

limitsofthetetherineachdirection,nostressistransmittedtotheelectricalconduit.



Afterinstallationoftherotisserieorwarmer,theoperatoroftheunithastobeinstructed.

Theinstructionhastocoverthefollowingsubjects:

• Programmingandoptions.

• Workingoftheunit.

• Freespaceofunitforcoolingofdrivemotorandblowers.

• Reviewtheusermanual.

• Periodicalmaintenance:

o Cleaningoffanplateeverymonth.

• Howtoreactforinformationorservicecalls.

INSTRUCTIONS FOR OPERATORS

Theovenmustbeburnedintoreleaseanyodorsthatmightresultfromheatingthenewoven

surfaces.Operatetheovenatmaximumtemperaturesettingof482°Ffor30minutesandthe

warmeron210°F.Smokewithanunplaesantodourwillnormallybegivenoffduringthisburn-

inperiod.

TEST RUN

Althoughanextractionhoodisnotprescribed,itcouldbedesiredthatahoodisplacedover

therotisserie.TheTDR8producesabout350cfwatervapourandtheTDR5about200cf.When

placingtherotisserieunderanextractionhoodyouhavetoconsiderthefollowingguidelines:

-Theminimumcapacityoftheextractionhoodhastobe25000cf/h.

-Theextractionhoodhastoextendminimumby8”onallsidesoftherotisserie.

-Theextractionhoodhastohaveafreehight,abovetherotisserie,ofaminimumof12”.

-Therotisseriehastobeaccessibleforservicepurposes.

-Theextractionhoodhastobeslopingontheinsideforthecondensationtorundown.Around

thehoodtherehastobeagutterwithaconnectionforthewatertorundownadrain.

HEAT EXTRACTION OF THE ROTISSERIE


PLACING AND CONNECTING



Description belonging to the lables on the drawingsLabel Description

1 Power cable, length 70” *

2 Exhaust opening

3 Space between a rotisserie and a wall or ceiling

4 Location for socket

*) length is measured from the point where the cables coms out of the unit

TDR 5 M PASS THROUGH

PLACING AND CONNECTING OF THE MODELS



TDR 5 P PASS THROUGH



TDR 8 M PASS THROUGH



TDR 8 P PASS THROUGH



TDR 5 + 5 M PASS THROUGH



TDR 5 + 5 P PASS THROUGH



TDR 8 + 8 M PASS THROUGH



TDR 8 + 8 P PASS THROUGH



TDRW 5 M PASS THROUGH



TDRW 5 P PASS THROUGH



TDRW 8 M PASS THROUGH



TDRW 8 P PASS THROUGH



TDR 5 M AND TDR 5 P PASS THROUGH ON BASE



TDR 8 M AND TDR 8 P PASS THROUGH ON BASE



TDW 5 M PASS THROUGH



TDW 5 P PASS THROUGH



TDW 8 M PASS THROUGH



TDW 8 P PASS THROUGH


EMPTY PAGE

For technical support call: 877 374-5236For parts call: 877 392-7851

Fri-Jado Inc. •1401 Davey Road • Sweet 100 • Woodridge, IL. 60517 • USA • tel. 630-630-7950 • fax 630-689-11424 • toll free 877-FRI-JADO • [email protected] • www.frijado.com

Date post:	15-Mar-2020
Category:	Documents
Upload:	others
View:	4 times
Download:	0 times

TDR - ROTISSERIE OVEN MODELS TDW - WARMER MODELS• TDW 5 - Warming cabinet 25 to 30 chickens. •...

Documents