*Some face widths are not available in all horsepowers. For minimum available face widths refer to page 19.**Idler dimensions are identical to the drum motor with no junction box.

TM215B40 Drum Motor (matching Idler KT215B40**)

Standard face widths* (L) in inches:19.69 21.65 23.62 25.59 27.56 29.53 31.50 33.46 35.43

37.40 39.37 41.34 43.31 45.28 47.24

UP

□1.30

Ø1.57

Ø8.5

4

Ø8.3

9

L + 0.40L

0.20 0.20

1.81

1.77

3.35

4.80

1.26

1/2˝ NPT3.74

0.24

1/2" NPT

Optional Cable Type

Note: When Optional Cable Type is selected, the minimum face width (L) increases by 1.969 inches.

1.30

5.917.28

1.30

.51

1.81

1.65

0.87

3.27

Bracket AB 40

TM215 SERIES (8.5" diameter) DIMENSIONS (in inches)

www.vandergraaf.com E-mail: info@vandergraaf.com Tel: +1 (905) 793-8100 ©2016 Van der Graaf Inc. All Rights Reserved. Van der Graaf Inc. holds the rights on modifying the designs and its specifications and others noted here. E&OE. d_215 (06/2019)

_COVER Junet2016_TM100 to TM215 NEW.ai_INDEX V2 JULY2015_CatalogTM100 to TM215.ai1 _benefits P1_new CUTAWAY 2016.ai2 _features P2_newPOWERhookUP.ai3 _options P3_new.ai4 _options contd P4_new.ai5 d_TM100B25_2012 P5.ai6 s_TM100_specsA_SEPT.ai7 s_TM100_specsB_SEPT.ai8 d_TM113B25_2012.ai9 s_TM113_specsA_NOV.ai10 s_TM113_specsB_SEPT.ai11 d_TM127AB25_2012.ai12 s_TM127_specs_NOV.ai13 d_TM138AB25_2012.ai14 s_TM138_specsA_SEPT.ai15 d_TM160AB30_2012.ai16 s_NEW 3TM160_specsA_June2016.ai17 d_TM215AB40_2012.ai18 s_TM215_specsA_NEW SEPT.ai19_rev1 MINIMUM FACE WIDTH CHART_Standard Duty.ai20_VDG_DM_amps table A rev1.ai21_VDG_DM Analysis study.ai22_VDG_DM NEW_DiagAandB.ai23_VDG_DM_BP Calculations_v2.ai24_NOTES.aiBACK NEW TM100-TM215 JUNE 2016_v5.aiBlank Page