Full Dash Cover TXT Models
Remove the steering wheel and cutout a 4"X15" area out of the O.E.M.dash (A). Install the Radio/Speakersinto new dash. Slide dash over steeringcolumn and set into car dash area. Tosupport the radio use a piece of 3 3/4"Aluminum or steel (1/8" thick) and bendat an angle to fit the rear mount studon radio. The other end mount to thedriver's side compartment (C). Routeall wiring at this time. Install six #6 X 1/2"screws spaced evenly to secure thedash to car (D). Install the three mountingbolts supplied with kit. Drill through floorfor bolt installation (5/16" drill). Onemore will be found under lid (E).
A
C
D
E
(B) Mounted To Car
B
Note: move the key switch and plateas shown in (B).