Date post: | 05-Jan-2016 |
Category: |
Documents |
Upload: | patience-ryan |
View: | 216 times |
Download: | 2 times |
Use of Node Locate in a very large Piping Model
TRIFLEX® WINDOWSPipingSolutions, Inc. 22 June 2004
1
Open your file within TRIFLEX ®.
TRIFLEX® WINDOWSPipingSolutions, Inc. 22 June 2004
2
Adding Node Points creates a problem in reading the Node Points because the model is so large.
TRIFLEX® WINDOWSPipingSolutions, Inc. 22 June 2004
3
Pick Node Locate on the Vertical Task Bar.
TRIFLEX® WINDOWSPipingSolutions, Inc. 22 June 2004
4
Pick Node Locate on the Task Bar.
Now suppose you are looking for Node Point 1700.
TRIFLEX® WINDOWSPipingSolutions, Inc. 22 June 2004
5
Type in 1700 in the Node Number box.
After saying OK to Node Point 1700. Then turn off the Node Points and see that TRIFLEX ® has
located your requested Node Point.
TRIFLEX® WINDOWSPipingSolutions, Inc. 22 June 2004
6
Turn Off the Node Points by picking the Node Point box again.
Note the location of Node Point 1700.
Now Zoom into the area that TRIFLEX ® has shown you.
TRIFLEX® WINDOWSPipingSolutions, Inc. 22 June 2004
7
Notice that TRIFLEX ® shows you the Node Point by marking it with a Axis Marker.
Now Zoom again and you have your Node Point 1700.
TRIFLEX® WINDOWSPipingSolutions, Inc. 22 June 2004
8
Notice the Axis Marker again
Now Add the Node Points to see your Node Point 1700.
TRIFLEX® WINDOWSPipingSolutions, Inc. 22 June 2004
9
Now you have located the Tee which is Node Point 1700.
Picking the Toggle Axis will turn off the Marked Axes. Then continue on.
TRIFLEX® WINDOWSPipingSolutions, Inc. 22 June 2004
10
Pick Toggle Axis