V. Solutions

2

A solution is a homogeneous mixture of a solute dissolved in a solvent. The solubility of a solute in a given amount of solvent is dependent on the temperature, the pressure, and the chemical natures of the solute and solvent.

Dissolved particles are too small to be trapped by a filter

3

Regents Question:Which mixture can be separated by using the

equipment shown?

(1) NaCl(aq) and SiO2(s)

(2) NaCl(aq) and C6H12O6(aq)

(3) CO2(aq) and NaCl(aq)

(4) CO2(aq) and C6H12O6(aq)(aq) stands for aqueous which means dissolved in water.

Dissolved particles are too small to be trapped by the filter.

4

Solubility of a nonvolatile solute depends on temperature. Solubility is the maximum amount of solute that a

solvent can hold at a given temperature.– An unsaturated solution is one in which the solvent

can dissolve more solute– A saturated solution is one in which the solvent has as

much solute as it can hold– A supersaturated solution is one in which there is

more solute dissolved than a solvent can normally hold.• Make a supersaturated solution by cooling a saturated solution• Supersaturated solutions are unstable and will precipitate the

excess solute when a seed crystal is added.

As temperature increases, solubility of a solid increases.

5

Table G shows the solubilities of some gases and some solids at various temperatures when dissolved in 100 grams of water.

6

•A solution which is on the line is saturated

•A solution below the line is unsaturated

•A solution above the line is supersaturated

7

Add a test crystal to see if a solution is unsaturated, saturated or supersaturated.

Unsaturated – the test crystal dissolves Saturated – the test crystal settles to the

bottom Supersaturated – a large amount of crystals

precipitate from the solution

8

Regents Question:

According to Reference Table G, which solution is saturated at 30°C?

(1) 12 grams of KClO3 in 100 grams of water

(2) 12 grams of KClO3 in 200 grams of water

(3) 30 grams of NaCl in 100 grams of water

(4) 30 grams of NaCl in 200 grams of water

9

The solubility of a gas depends on temperature and pressure.

As temperature increases, the solubility of a gas decreases

As pressure increases, the solubility of a gas increases

10

Which are gases?

11

Regents Question:

One hundred grams of water is saturated with NH4Cl at 50°C. According to Table G, if the temperature is lowered to 10°C, what is the total amount of NH4Cl that will precipitate?

(1) 5.0 g (3) 30. g

(2) 17 g (4) 50. g

12

Regents Question:

When cola, a type of soda pop, is manufactured, CO2 (g) is dissolved in it.

A capped bottle of cola contains CO2 (g) under high pressure. When the cap is removed, how does pressure affect the solubility of the dissolved CO2 (g)?

A glass of cold cola is left to stand 5 minutes at room temperature. How does temperature affect the solubility of the CO2 (g)?

13

Oil and water are not miscible Like dissolves like (charged

solutes dissolve in charged solvents, uncharged solutes dissolve in uncharged solvents)– Nonpolar solutes dissolve in

nonpolar solvents– Polar solutes dissolve in polar

solvents – Ionic solutes dissolve in polar

solvents

Dry cleaners use a nonpolar solvent to get rid of oil and grease

Liquids that dissolve each other are called miscible liquids.

(Polar)

(Nonpolar)

14

Regents Question:

Hexane (C 6 H 14 ) and water do not form a solution. Which statement explains this phenomenon?

(1) Hexane is polar and water is nonpolar.

(2) Hexane is ionic and water is polar.

(3) Hexane is nonpolar and water is polar.

(4) Hexane is nonpolar and water is ionic.

15

Solubility Guidelines

Not all substances are soluble in water Reference Table F lists solubility rules and

exceptions to those rules.

16

Soluble Not Soluble

17

Regents Question:

Which of the following compounds is least soluble

in water?

(1) copper (II) chloride

(2) aluminum acetate

(3) iron (III) hydroxide

(4) potassium sulfate

18

Regents Question:

According to Table F, which of these salts is least soluble in water?

(1)LiCl

(2) RbCl

(3) FeCl2

(4) PbCl2

19

The concentration of a solution may be expressed as molarity (M), percent by volume, percent by mass, or parts per million (ppm).

Molarity Percent by mass Parts per MillionM = moles solute % = grams solute x 100 ppm = grams solute x 1,000,000

Liters solution Grams solution Grams solution

Percent by volume% = liters solute x 100

Liters solution

20

Regents Question:

What is the molarity of a solution that contains 0.50 mole of NaOH in 0.50 liter of solution?

(1) 1.0 M (3) 0.25 M

(2) 2.0 M (4) 0.50 M

Molarity = Moles

Liters

21

Regents Question:

How many moles of solute are contained in 200 milliliters of a 1 M solution?

(1) 1 (3) 0.8

(2) 0.2 (4) 200

22

Regents Question:

What is the total number of grams of NaI(s) needed to make 1.0 liter of a 0.010 M solution?

(1) 0.015 (3) 1.5

(2) 0.15 (4) 15Na 1 x 23.0 = 23.0

I 1 x 126.9 = 126.9

149.9 g / mole

Molarity = moles

liters

0.010M = x 1.0 L

X = 0.010 moles 0.010 moles x 149.9 g/mole =

23

Regents Question:

Solubility data for four different salts in water at 60°C are shown in the table below. Which salt is most soluble at 60°C?

(1) A (2) B (3) C (4) D

Salt Solubility in Water at 60 °C

A - 10 grams /50 grams H2O

B - 20 grams /60 grams H2O

C - 30 grams /120 grams H2O

D - 40 grams/80 grams H2O

24

Regents Question:A student uses 200 grams of water at a

temperature of 60°C to prepare a saturated solution of potassium chloride, KCl.

Identify the solute in this solution.

According to Reference Table G, how many grams of KCl must be used to create this saturated solution?

This solution is cooled to 10°C and the excess KCl precipitates (settles out). The resulting solution is saturated at 10°C. How many grams of KCl precipitated out of the original solution?

25

The addition of a nonvolatile solute to a solvent causes the boiling point of the solvent to increase and the freezing point of the solvent to decrease. The greater the concentration of particles, the greater the effect.

Solute Moles of particles per mole of solute

C6H12O6 1 (Non-electrolytes do not separate into ions)

NaCl 2 (1-Na+ and 1 Cl-)

CaF2 3 (1-Ca2+ and 2 F-)

H2SO4 3 (2-H+ and 1 SO42-)

26

Regents Question:

At standard pressure when NaCl is added to water, the solution will have a

(1) higher freezing point and a lower boiling point than water

(2) higher freezing point and a higher boiling point than water

(3) lower freezing point and a higher boiling point than water

(4) lower freezing point and a lower boiling point than water

27

Regents Question:

Compared to pure water, an aqueous solution of calcium chloride has a

(1) higher boiling point and higher freezing point

(2) higher boiling point and lower freezing point

(3) lower boiling point and higher freezing point

(4) lower boiling point and lower freezing point

28

The structure and arrangement of particles and their interactions determine the physical state of a substance at a given temperature and pressure.

Solid Liquid Gas

29

Intermolecular forces created by the unequal distribution of charge result in varying degrees of attraction between molecules. Hydrogen bonding is an example of a strong intermolecular force.

Dipole-Dipole attraction between polar molecules

30

Hydrogen bonds occur when hydrogen is bonded to a small, highly electronegative atom.N, O and F can have hydrogen bonds when hydrogen is bonded to it.Account for the unusual properties of water:High boiling point, surface tension, six sided snowflake

31

Physical properties of substances can be explained in terms of chemical bonds and intermolecular forces.

•Ionic bonds are strong

•Hydrogen bonds are strong intermolecular forces

•Polar molecules exhibit attraction between the + and – sides of their molecules

•Bonds between nonpolar molecules are weak. The more protons in the molecule, the stronger these forces.

32

Regents Question:

The strongest forces of attraction occur between

molecules of

(1) HCl (3) HBr

(2) HF (4) HI

33

These properties include conductivity, malleability, solubility, hardness, melting point, and boiling point. The stronger the intermolecular forces, the

higher the boiling point and melting point. The stronger the intermolecular forces, the

lower the vapor pressure.– See Table H

34

Table H – the vapor pressure of four liquids at various temperatures.

As temp inc, vapor pressure inc.

35

Regents Question:

According to Reference Table H, what is the vapor pressure of propanone at 45°C?

(1)22 kPa

(2)33 kPa

(3)70. kPa

(4) 98 kPa

36

A liquid will boil when its vapor pressure equals the atmospheric pressure.

Raising the temperature will increase the vapor pressure of the liquid

Lowering the atmospheric pressure will lower the boiling point– On top of a high mountain, water boils at a

temperature below 100C

37

Standard pressure is 101.3 kilopascals (kPa) or 1 atmoshpere (atm)The normal boiling point occurs when the atmospheric pressure is 101.3 kPa (standard pressure)

The normal boiling point of ethanol is 80ºC.

38

Regents Question:

As the pressure on the surface of a liquid decreases, the temperature at which the liquid will boil

(1) decreases

(2) increases

(3) remains the same

39

Regents Question:

As the temperature of a liquid increases, its vapor pressure

(1) decreases

(2) increases

(3) remains the same

40

Regents Question:

The vapor pressure of a liquid is 0.92 atm at 60°C. The normal boiling point of the liquid could be

(1) 35°C (3) 55°C

(2) 45°C (4) 65°C

41

Regents Question:What is the vapor pressure of liquid A at 70°C?

Your answer must include correct units.

42

Regents Question:At what temperature does liquid B have the

same vapor pressure as liquid A at 70°C?

Your answer must include correct units.

43

Regents Question:Which liquid will evaporate more rapidly? Explain

your answer in terms of intermolecular forces.