7/28/2019 11.4. Sulphuric Acid
1/14
Objectives:
7.1 Describe the contact process for themanufacture of sulphuric acid.
7.2 Discuss the industrial importance of
compounds of sulphur. 7.3 Assess the impact of sulphuric
industry.
7/28/2019 11.4. Sulphuric Acid
2/14
Sulphuric acid is produced commerciallyusing the contact process. The rawmaterial needed are source of sulphurdioxide, air, water and a catalyst. The mainstages are:
Production of sulphur dioxide
Oxidation of sulphur dioxide to sulphurtrioxide
Hydration of the sulphur trioxide tosulphuric acid.
7/28/2019 11.4. Sulphuric Acid
3/14
This can be produced by: Burning sulphur in an excess of air
S(s)+O2 SO2 (g)
Heating sulphide ores like pyrite in an excess air
4FeS2(s)+1102(g) 2Fe2O3(s)+ 8SO2(g)
Decomposing calcium sulphate in the presenceof coke
2CaSO4(s)+C(s)
2CaO(s)+CO2(g)+2SO2(g)
7/28/2019 11.4. Sulphuric Acid
4/14
A catalyst, ideally vanadium (V) oxide, is needed
for this stage in the process. The oxygen issupplied by the addition of excess air to sulphurdioxide and is purified by an electrostaticprecipitator.
The purified sulphur dioxide combines withoxygen in the presence of this catalyst to form theanhydride of sulphuric acid, sulphur trioxide.
2SO2(g)+O2(g) 2SO3(g) H = -196kJ/ mol
7/28/2019 11.4. Sulphuric Acid
5/14
This reaction is a reversible and theforward one is exothermic one.
It would be ideal, according to LeChateliers Principle, for the conditionsof this process to be low temperatureand high pressure.
2SO2(g)+O2(g)2SO3(g) H = -196kJ/ mol
7/28/2019 11.4. Sulphuric Acid
6/14
But at low temperatures the reaction rate
would be too slow to be economical. And high pressures would result in the sulphur
dioxide to liquefy.
Then,
A catalyst is needed, to increase the rate of
reaction without affecting the position of the
equilibrium.
Vanadium oxide is used with a temperature
of about 450C to produce a fairly high yield
of sulphur trioxide at an acceptable rate.
7/28/2019 11.4. Sulphuric Acid
7/14
Since the reaction is exothermic, as itproceeds, the temperature of the surroundingsystem rises to 600C from 450C. At thistemperature, the yield is reduced toapproximately 70%. Thus to give a yield ofabout 98%, the gases are cooled to about450C between successive layers of catalyst.
A closed water circuit, is usually used as thecooling system in which energy is recovered assteam, this reducing the use of externalheating.
Close to atmospheric pressure is used whichgives an approximate yield of 98%, althoughhigh pressure gives greater yield of sulphur
trioxide in the equilibrium mixture.
7/28/2019 11.4. Sulphuric Acid
8/14
A counter flow system is usually done inthe industry, where water is sprayeddownward over the upward flowing gas.
However, because this will produceuncontrollable, toxic, hard to condenseclouds of sulphuric acid, this method
cannot be used. Concentrated sulphuric acid destroys
skin and flesh and can cause blindness ifeye is contacted.
7/28/2019 11.4. Sulphuric Acid
9/14
INSTEAD, the sulphur trioxide is first dissolved inconcentrated sulphuric acid to form oleum.
H2SO4 (l)+ SO3 (g) H2S2O7 (l)
Then is diluted with water to produce,concentrated sulphuric acid.
H2
S2
O7 (l)
+ H2
O(l)
2H2
SO4 (l)
7/28/2019 11.4. Sulphuric Acid
10/14
Uses ofSulphur:to produce sulphur dioxide to make
sulphuric acid
used in the vulcanization of naturalrubber to improve its elasticity and tensilestrength
( its makes the rubber less sticky and less soluble
in organic solvents)
used as fungicide and as a fumigant
7/28/2019 11.4. Sulphuric Acid
11/14
Uses ofSulphur dioxide (a reducing agent):
used for bleaching wool, straw and paper
and as an antioxidant in food
preservation. Uses of Sulphuric Acid:
used in the manufacture of:
fertilizersdetergents
car batteries
high strength fibres paints
pigments
- petroleum refining and metallurgy
7/28/2019 11.4. Sulphuric Acid
12/14
Advantages of The Contact Process:
Sulphuric acid production reduces the
amount of sulphur dioxide emited into the
atmosphere.
Emission of sulphur dioxide from the
Contact Process is minimized by recycling
unreacted sulphur dioxide. In addition,scrubbing tail gas with a basic solution.
Recycling and regenerating Sulphuric Acid
is another positive impact on the industry.
7/28/2019 11.4. Sulphuric Acid
13/14
Also spent catalyst from the Contactprocess is either disposed in a suitablylicensed landfill site or its vanadiumcontent is recovered and recycled.
Heat energy is also recycled, when heatevolved from the process is used to turnwater into steam, which is in turn used to
generate electricity. The environment is protected, as no
Carbon dioxide is formed because fossilfuel is not used.
7/28/2019 11.4. Sulphuric Acid
14/14
During production, handling and storageof sulphuric acid, there is always a risk ofaccidental leaks which may have a
negative impact on the environment.
Thus precautions and safety measures
must be implemented to reduce theserisk possibilities.