The Touchpad control panel

…all equipment is controlled from here touch it with your finger to start

laptopconnectors: display, sound, network

when you touch the screen you’ll see:

the system takes a moment to turn onwhile the projector starts.Give it a few seconds.

•Next, you’ll see the Sources screen.•Touch the “button” you want to display•The “System Off” button turns everything off when you’re finished.

laptopvhs tape

dvd player

cable stations(if equipped)

turn everythingOFF

The laptop screen:

Mac laptops need a video adapter. Check with the media center or bring your own.

control volumehere

touch sourcesto change displayto DVD or VCR

touchsystem offwhen done

“System Off” button turns everything offDon’t turn off individual equipment inside cabinet only use touchpad

You’ll see this screen while projector turns off.

No display?

May have to “re-sync” controls

1. touch “sources” (upper right)

2. select diffferent device

3. touch “sources” again, and

4. ….select original device

No sound?

• Is sound muted? Touch the mute button (right hand side).

• Is sound turned down? Press the VOL UP button

• Is the correct device selected? Press “sources” upper right

Pressing too hard?

• Just kidding. You can’t really mess up the touchpad (unless you hit it with a hammer or throw it)

• Touch away, try things out.

• It’s as simple as we could make it. See following screen for schedule of help sessions.

Schedule of training sessions

when: DAILY Monday-Friday

(Aug. 27 - 31)

time: 9 AM, NOON, 3 PM

where: Media Center Classroom

(library lower level)