Post on 25-Aug-2020
transcript
PROCENTECThe PROFIBUS and PROFINET Company
CONFIDENTIAL Copyright © 2011 PROCENTEC. All rights reservedPROCENTEC
The PROFIBUS and PROFINET CompanyCOMbricks – Installation
>>> Distribucion: ER-Soft, S.A. www.er-soft.com info@er-soft.com Tel: +34 916-408-408 <<<
(Un‐)Mounting the backplane
CONFIDENTIAL Copyright © 2011 PROCENTEC. All rights reservedPROCENTEC
The PROFIBUS and PROFINET Company18 April 2011COMbricks Installation 2
Adding backplane units
CONFIDENTIAL Copyright © 2011 PROCENTEC. All rights reservedPROCENTEC
The PROFIBUS and PROFINET Company18 April 2011COMbricks Installation 3
Detaching backplane units
CONFIDENTIAL Copyright © 2011 PROCENTEC. All rights reservedPROCENTEC
The PROFIBUS and PROFINET Company18 April 2011COMbricks Installation 4
Inserting modules
CONFIDENTIAL Copyright © 2011 PROCENTEC. All rights reservedPROCENTEC
The PROFIBUS and PROFINET Company18 April 2011COMbricks Installation 5
Removing modules
CONFIDENTIAL Copyright © 2011 PROCENTEC. All rights reservedPROCENTEC
The PROFIBUS and PROFINET Company18 April 2011COMbricks Installation 6
Wiring Ethernet
CONFIDENTIAL Copyright © 2011 PROCENTEC. All rights reservedPROCENTEC
The PROFIBUS and PROFINET Company18 April 2011COMbricks Installation 7
Powering the Head Station
Redundant power supply option
CONFIDENTIAL Copyright © 2011 PROCENTEC. All rights reservedPROCENTEC
The PROFIBUS and PROFINET Company18 April 2011COMbricks Installation 8
Discovery Tool
Scan and configuration functionsfunctions
Head Stations MAC and IP addressesMAC and IP addresses
CONFIDENTIAL Copyright © 2011 PROCENTEC. All rights reservedPROCENTEC
The PROFIBUS and PROFINET Company18 April 2011COMbricks Installation 9
Menu switch
CONFIDENTIAL Copyright © 2011 PROCENTEC. All rights reservedPROCENTEC
The PROFIBUS and PROFINET Company18 April 2011COMbricks Installation 10
Menu of the Head StationNormal menu(NL)
Hold upFor 5 seconds
Execution confirmed
(XC)
Done
SpecialMenu(SL)
Tap Down
Wait key(L1)
Read settings from SD card
Holdup for
5 seconds
Wait
Tap Down/Up
Hold
Done
TimeoutWait key(L2)
Save settings to SD card
Holdup for
5 seconds
Wait Clear
Tap Down/Up
Hold
DoneTimeout,
or held downfor 5 seconds LED behaviour
SL All LEDs Blinking
L1 RDY Blinkingkey(L3)
Clear password up for
5 seconds
Wait key
Reset to factory
Tap Down/Up
Holdup for
Done
Done
L1 RDY Blinking
L2 ETH Blinking
L3 SF Blinkingkey(L4)
factory defaults
up for5 seconds
Wait keyWarm start
Tap Down/Up
Holdup forDone
Done
L4 IOF Blinking
L5 USB Blinking
XC LED walk through
CONFIDENTIAL Copyright © 2011 PROCENTEC. All rights reservedPROCENTEC
The PROFIBUS and PROFINET Company18 April 2011COMbricks Installation 11
(L5)5 seconds
Tap Down/Up
gall the LEDs
Firmware update connector
CONFIDENTIAL Copyright © 2011 PROCENTEC. All rights reservedPROCENTEC
The PROFIBUS and PROFINET Company18 April 2011COMbricks Installation 12
Firmware update software
COMbricks is connected to USB and in the update
mode
Click here to browse to the .pkg file
mode
This window can be closed directly, but wait until COMbricks is ready
CONFIDENTIAL Copyright © 2011 PROCENTEC. All rights reservedPROCENTEC
The PROFIBUS and PROFINET Company18 April 2011COMbricks Installation 13
(check LEDs)
PROCENTECThe PROFIBUS and PROFINET Company
CONFIDENTIAL Copyright © 2011 PROCENTEC. All rights reservedPROCENTEC
The PROFIBUS and PROFINET CompanyCOMbricks – Installation
>>> Distribucion: ER-Soft, S.A. www.er-soft.com info@er-soft.com Tel: +34 916-408-408 <<<