Post on 31-Jul-2016
description
transcript
GUIDANCE NOTESfor Estimate Request
• Hob: Make | Model• Installation method: Standard | Rebate• Type: Gas | Electric
Appliances
Profiles*
• Tap holes• Drainer grooves: Quantity
Straight | Angled | Recessed• Pop up sockets• Air switch• Hot rods
Additional cut outs
• Splashback• Upstands - Coved or Square• Sills• Risers• Worktop end panels/Downstands• Waterstop
Additional items
• Type: Granite | Marble | Strata Quartz | Branded Quartz CORIAN Solid surfaceHI-MACS Solid surface | OtherTimber
• Please specify: Colour Material thicknessSurface finish
• Service Type: Supply to Drawing/TemplateTemplate & installation
Material
Finish
(Silestone, Caeserstone, etc)
Standard square edge R8mm Owl’s beak
R15mm Owl’s beak
Waterfall edge
Single pencil round
Arrow Slow bevel
3mm pencil round
Shark’s nose R15mm Bull Nose
Double R8mm
Curva
• Overhang: Full under polish | Half Underpolish• Underwrap/cladding** Solid surface only
Plan
Please provide:
• A sketch including all dimensions for all work pieces,upstands, splashbacks, sills, worktop downstands /end panels / risers etc.
• Confirmation if you are using handless doors
• Details regarding access
• Detail where cabinetry will be, particularly withbreakfast bars & islands, as we need to understandwhat support is being provided.
Please note:• All depths are measured at 620mm unless you request otherwise• Any work pieces over 2500mm may require joints, this will be confirmed at the point of template.
Please refer to the Directory, 3 Worksurfaces for tolerances.
*Please refer to the Directory, 3 Worksurfaces for options / tolerances | ** Please ask for clarification
PLEASE NOTE: IMAGE TO BE PROVIDED
• Sink: Make | Model• Type: Inset | Undermount | Belfast
Flush | Overhang
(Solid Surface only)
(Solid Surface only)
WS_0043_Request for Estimate_Layout 1 16/07/2015 15:12 Page 1