RMACES February 23The National Cooperative Highway Research Program (NCHRP) published their NCHRP...

Post on 27-Feb-2021

2 views 0 download

transcript

RMACES February 23th, 2017

Project Superintendent for APC Construction Company LLC

23 years experience in Heavy Highway Construction, Estimating, Project Management, Operations Management 

Current Construction Project Engineer for CDOT

Former Roadway Designer/Project Manager for Design

This specification gives minimum lighting requirements for night time construction. 

To understand this specification and how to properly setup your operation for night work, you need a basic understanding of how light is dispersed and how it is measured. 

The National Cooperative Highway Research Program (NCHRP) published their NCHRP Report 726: A Guidebook for Nighttime Construction: Impacts on Safety, Quality, and Productivity

In this report, the NCHRP identified the problem area and proposed solutions for those problems

○ Safety of Personnel ○ Safety of Traveling Public ○ Reduction in Quality ○ Increased Construction Nuisances

Two Parts – Must be balanced.  Provide the proper amount of light with minimal glare for our workers so that they can safely, effectively, and efficiently perform their work.  

Properly illuminate the work area in order to increase awareness and visibility of the work zone and the construction worker to the travelling public

For paving operations, minimum of 5 foot candles 25 feet in front of and behind and 5 feet each side of each piece of moving equipment. 

Light sources shall be positioned not to interfere with or impede traffic in any direction and not cause glare for motorists. 

Must maintain a uniformity ratio of 5:1 over work space. 

Highlights Clearly states amount of illumination and where Cleary states who and what must be illuminated Mentions glare and other safety issues

Lowlights (Old Pilot) Vague and contradictory on which direction the lights should

point (one part says perpendicular and parallel) Requires project to be shut down if any of the lights are shutoff

or burned out

We aren’t nocturnal so humans have poor night vision to start

We are used to a single point sourceof white light

(the sun) We don’t filterglare very well

Glare vs Contrast vs Luminance

High Mast vs Cobra Head Cutoff Lenses

Light Towers

Can be used in stationary applications or towed behind a vehicle for moving work zones

Flood/Spot Lights 

Overhead Lights – Balloon Lights

Overhead Lights – LED Overhead Light

Planning and Preparation Executing and Maintaining 

Visit the worksite at night  What is the topography of the roadway?   What type of lighting do you currently have on your equipment?   OEM or after market lights

Are there any best practices which work in different situations?  Urban corridor vs rural

Based on project location. Will you need to change your current lighting set up?

Urban projects tend have more permanent lighting present.

Rural projects you will need to provide all your own lighting to keep project safe and well lit.

Create a job specific lighting plan as a guide, set each piece of equipment with the lights required.  

Pre‐shift check lights to ensure all lights are operating correctly.

Keep extra lights onsite incase the replacement is required during shift.

Properly position lights so as not to interfere with traffic or crew.

Take into account the power needed for the lights, equipment retro-fitting may be required.

Train personnel in proper usage of lights.

Follow manufacturers installation recommendations.

Be aware of any structures which may interfere with lights.

Continuously monitor lighting plan. Communicate nightly with all personnel

on any changes.

This situation fulfills the specification but is not necessarily a safe or ideal solution according lighting design standards

This situation doesn’t fulfill the specification completely but seems to work well and is more practical

No matter how well your lighting plan is executed.

No matter how much planning and preparation you do.

We can’t account for all situations.

Proper lighting at night will increase the safety and the quality of your nighttime construction activities.

The “Specification” world and the “Real” world don’t always coincide so try and use common sense

Questions?