Title EMEA Advanced Technical Training Printer Configuration Open and run the DMX Configuration Tool...

transcript

Advanced Technical Training

Printer Configuration

Open and run the DMX Configuration Tool

For the next session we will be using this tool to demonstrate how to configure the printer

Default Opening Menu

During this session we will be working through

the various menus/tabs to learn how to configure the

printer

Information

Printer Type and Firmware

Current Connection

Media SettingsExercise 1

Measure the Length/height of the label, that is being used.

Now set the label length to a setting shorter than this figure

Exercise 2

Set Label width to a value of 2”

Exercise 3

Set Paper Out Distance to a value of 4.0”

Print Control Exercise 1

Set Present Distance to a value of 2”

Exercise 2

Set present adjust to a value of +32

Exercise 3

Set present adjust to a value of -32

Printer OptionsExercise 1

Enable cutter and disable cutter

Memory ModulesExercise 1

Select a graphic and send to printer module G

Exercise 2

Select a TTF font and send to printer

System Settings

Exercise 1

Select and change Menu Language

Exercise 2

Select Menu Mode and change

Host Connection

NetworkWe will cover this section

at a later time

Sensor Calibration

Exercise 1

Change the values of the settings to see what effect they have

Communications 1

Communications 2

User Functions

Questions

Documents