Title
EMEA
Advanced Technical Training
Printer Configuration
Open and run the DMX Configuration Tool
For the next session we will be using this tool to demonstrate how to configure the printer
Title
EMEA
Advanced Technical Training
Printer Configuration
Default Opening Menu
During this session we will be working through
the various menus/tabs to learn how to configure the
printer
Information
Printer Type and Firmware
Current Connection
Title
EMEA
Advanced Technical Training
Printer Configuration
Media SettingsExercise 1
Measure the Length/height of the label, that is being used.
Now set the label length to a setting shorter than this figure
Exercise 2
Set Label width to a value of 2”
Exercise 3
Set Paper Out Distance to a value of 4.0”
Title
EMEA
Advanced Technical Training
Printer Configuration
Print Control Exercise 1
Set Present Distance to a value of 2”
Exercise 2
Set present adjust to a value of +32
Exercise 3
Set present adjust to a value of -32
Title
EMEA
Advanced Technical Training
Printer Configuration
Printer OptionsExercise 1
Enable cutter and disable cutter
Title
EMEA
Advanced Technical Training
Printer Configuration
Memory ModulesExercise 1
Select a graphic and send to printer module G
Exercise 2
Select a TTF font and send to printer
Title
EMEA
Advanced Technical Training
Printer Configuration
System Settings
Exercise 1
Select and change Menu Language
Exercise 2
Select Menu Mode and change
Title
EMEA
Advanced Technical Training
Printer Configuration
Host Connection
Title
EMEA
Advanced Technical Training
Printer Configuration
NetworkWe will cover this section
at a later time
Title
EMEA
Advanced Technical Training
Printer Configuration
Sensor Calibration
Exercise 1
Change the values of the settings to see what effect they have
Title
EMEA
Advanced Technical Training
Printer Configuration
Communications 1
Title
EMEA
Advanced Technical Training
Printer Configuration
Communications 2
Title
EMEA
Advanced Technical Training
Printer Configuration
User Functions
Title
EMEA
Advanced Technical Training
Questions