Post on 21-Jun-2018
transcript
Title slide/end slide image dimensions:
Title slide images must always fit this size:
Height: 10.6 cm; Width: 25.4 cm
Title slide images must always follow this position:
Horizontal: 0 cm; Vertical: 0 cm
To change title slide/end slide image:
Contact Communication Support
Tip:
Vestas drawing guides will help you position and
crop images and objects. Images and objects will
snap to drawing guides when repositioned or
cropped.
To add drawing guides:
• Right-click on next to slide
• Select „Grid and Guides…‟
• Check „Display drawing guides on screen‟
• Press „OK‟
Add presentation information via
View/Header and Footer
To add pre-formatted bullets please
use the increase/decrease indent
buttons found in the PowerPoint menu
2
Add presentation information via
View/Header and Footer
To add pre-formatted bullets please
use the increase/decrease indent
buttons found in the PowerPoint menu
3
Add presentation information via
View/Header and Footer
To add pre-formatted bullets please
use the increase/decrease indent
buttons found in the PowerPoint menu
4
Add presentation information via
View/Header and Footer
To add pre-formatted bullets please
use the increase/decrease indent
buttons found in the PowerPoint menu
5
Source: IHS emeging energy research. Nov 2011
Add presentation information via
View/Header and Footer
To add pre-formatted bullets please
use the increase/decrease indent
buttons found in the PowerPoint menu
6
Source: WTO Tariff Download Facility
Add presentation information via
View/Header and Footer
To add pre-formatted bullets please
use the increase/decrease indent
buttons found in the PowerPoint menu
7
Buy National
Local Content
Tariff Barrier
Tariff Barrier
Buy National
Local Content
Local Content
Local Content
Local Content
Local Content
Tariff Barrier
Anti-dumping
Anti-dumping
Buy National
Buy National
Buy National
Buy National Tariff Barrier
Buy National
Buy National
Buy National
Buy National Tariff Barrier
Local Content
Local Content
Add presentation information via
View/Header and Footer
To add pre-formatted bullets please
use the increase/decrease indent
buttons found in the PowerPoint menu
8
Add presentation information via
View/Header and Footer
To add pre-formatted bullets please
use the increase/decrease indent
buttons found in the PowerPoint menu
9
Add presentation information via
View/Header and Footer
To add pre-formatted bullets please
use the increase/decrease indent
buttons found in the PowerPoint menu
10
Add presentation information via
View/Header and Footer
To add pre-formatted bullets please
use the increase/decrease indent
buttons found in the PowerPoint menu
11
Title slide/end slide image dimensions:
Title slide images must always fit this size:
Height: 10.6 cm; Width: 25.4 cm
Title slide images must always follow this position:
Horizontal: 0 cm; Vertical: 0 cm
To change title slide/end slide image:
Contact Communication Support
Tip:
Vestas drawing guides will help you position and
crop images and objects. Images and objects will
snap to drawing guides when repositioned or
cropped.
To add drawing guides:
• Right-click on next to slide
• Select „Grid and Guides…‟
• Check „Display drawing guides on screen‟
• Press „OK‟
Copyright Notice
The documents are created by Vestas Wind Systems A/S and contain copyrighted material, trademarks, and other proprietary information. All rights reserved. No part of the documents may be reproduced or copied in any form or by any
means - such as graphic, electronic, or mechanical, including photocopying, taping, or information storage and retrieval systems without the prior written permission of Vestas Wind Systems A/S. The use of these documents by you, or
anyone else authorized by you, is prohibited unless specifically permitted by Vestas Wind Systems A/S. You may not alter or remove any trademark, copyright or other notice from the documents. The documents are provided “as is” and
Vestas Wind Systems A/S shall not have any responsibility or liability whatsoever for the results of use of the documents by you.