3
400W LED Dimmable Parking Lot Light WIFI-CON User Manual Part Number: Important: Read all instructions prior to installation. APLD-NW400-2048 4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com Rev Date: V1.0 07/26/2017 Optional Accessories Specifications Safety and Notes Accessory Attachment Slip Fitter Installation (Included or APL-SF76) APLD-NW400-2048 Intensity 50000 lm Replacement For 1200 Watt HID Total Power Consumption 400 Watts (±10W) Power Factor >0.9 Operating Voltage Range 200~480 VAC Beam Angle TYPE IV (100 x 140) Dimensions 14in W x 30in L x 5in H (35.6cm x 76.2cm x 13cm) Color Temperature 5000 K CRI 70 Operating Temperature -49~113°F (-45~45 °C) IP Rating Weatherproof IP65 LED Lifetime 50,000 Hours Fixture Weight 38 lbs 8 oz (17.46Kg) Standards and Certifications ETL / RoHS Warranty 5 Years Large Square Pole Mount Kit (APL-ALS) Large Round Pole Mount Kit (APL-ALR) Wall Mount Kit (APL-AWB) Slip Fitter Mount 76mm (APL-SF76) All accessories are available at superbrightleds.com • Secure hardware properly-Fixture is heavy. • Consult with qualified electrician to install with national, local and state codes. 1. Choose mounting accessory per application (60mm comes attached). 2. Remove M12x50mm long socket head cap screw with 10mm allen(not included). 3. Remove current mounting accessory and attach new mounting accessory in it’s place. 4. Secure with M12x50mm long socket head cap screw. Slip Fitter Pole M12x50mm screw NOTE: Make sure hardware is properly attached and secured tightly after aiming. Light fixture is heavy. Wiring Diagram Line Neutral Ground Black L L N N GND GND White Dim (+) Dim (-) Purple + + - - Gray Green 1. Remove power prior to installation. 2. Loosen screws on side of Slip Fitter. 3. Connect wiring to power supply wires. Black to Line, White to Neutral, and Green to Ground. If 1~10V dimming is used, connect Black to DIM+ and White to DIM-. Consult electrician and install according to national, local, and state codes. 4. Attach Slip Fitter to top of pole. 5. Tighten all hardware on side of Slip Fitter 6. Adjust angle per application by loosening M12x50mm long socket head cap screw with 10mm allen (not included).
