Change Of Carboran Tub
2
IntroductionIntroduction
The substitution of the bearing or the tub of the Electrolux washing machines with Carboran tub is very workintensive.This presentation will show the way how to do it. A service engineer can do that work within 2 or 3 hours.
3
First StepsFirst Steps
Order of all necessary spare parts:- Back tub half with bearing- if necessary bearing cross- Damper nails
4
Disassemble ApplianceDisassemble Appliance
Disassemble top cover, back panel, cross brace and panel
5
Disassemble ApplianceDisassemble Appliance
Disassemble front panel, door lock, plinth, bellows
6
Disassemble ApplianceDisassemble Appliance
Disassemble all hose connections at the tub, drive belt anddrawer.
Attention: Air trap is fixed by a screw on thetub.
7
Disassemble ApplianceDisassemble Appliance
Disassemble pulley!!!!!!The screw of the pulley is protected by Locktight. Before opening the screw, you have to hit 2 or 3 times with a hammer on it. Then you can open the screw with help of an lever. Open it fitfully.
8
Disassemble ApplianceDisassemble Appliance
Disassemble heating element, earth connection und motor.
Attention: Take care that the motor (4 screws) will not dropp on the floating switch when you remove it from the tub.
9
Disassemble ApplianceDisassemble Appliance
Disassemble tub (12 or 14 screws)
Open the tub screws and remove the front tub half.Important!!! The heating element must be removed!!!
10
Disassemble ApplianceDisassemble Appliance
Removement of the drum and drum cross
Take a rubber mallet and hit some times on the drum axis. Thenremove the drum from the back tub half.
If the drum cannot be removed(e.g. deposit corrossion), then youhave to disassemble the drum cross.See next page.
11
Substitution Of Drum CrossSubstitution Of Drum Cross
When it is not possible to move the drum out of the tub, thenyou can disassemble the drum cross screws through thehose connection hole of the tub.After that you can remove the drum.
12
Substitution Drum CrossSubstitution Drum Cross
1. Push with the hammer on the screws (Locktight)2. Remove screws3. Disassemble the drum cross
13
Substitution drum crossSubstitution drum cross
14
Disassemble DampersDisassemble Dampers
- Press damper nails out of the dampers. Then take off the backtub half
15
Assemble ApplianceAssemble Appliance
After the repair or change of the defective parts you should assemble the appliance again.. Please pay special attention that the earth wire will not be crimped like in the photo.
Important: Take care that all electrical and water connections are done correctly.
16
Assemble ApplianceAssemble Appliance
Important!!! The screws of the drum cross and pulley must be fixed with Locktight.
17
Safety TestSafety Test
Do not forgett!!!!
VDE – Safety test on the appliance after repair
Change Of Carboran Tub