This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.

LOGAN

LOGAN

Installation manual: Parrot MKi + Parrot CK3100 range

The brand name DACIA LOGAN and the DACIA logo are the property of DACIA. This document is only valid for the vehicle model LOGAN® year 2008 to 2011, excluding all other models in the same range and excluding later modifications made to the vehicle by the manufacturer. The Parrot brand name and logos are the exclusive property of Parrot SA.

This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.

LOGAN

Accessories required

Disassembly 15min

Mounting kit 20min

Reassembly 15min

Testing 15min

Total 1h 05min

YES +IGN

YES ISO

N/A UNIKA

FRONT LOUDSPEAKER TEL mode

ALL MUSIC mode

Fitting time (estimated) / Main features

Tools

-Multimeter or Test lamp

- Wire tie

-Electrical tape

"Please contact your wholesaler to purchase accessories. A list of wholesalers is available at www.certified.parrot.com. "

To get the most out of your hands-free kit we recommend that you update your software regularly. The update procedure can be found at

www.parrot.com/usa/support/downloads

Updating

Plastic trim removal tools FACOM / BOJO

FACOM DX-25 kit (n°4 tools)

This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.

LOGAN

Disassembly

This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.

LOGAN

Disassembly

Insert the removal tools into the slots on each side of the radio.

Unclip the radio, pull it out and unplug the connectors and the

antenna then remove the radio.

Using the plastic trim removal tools, unclip the car stereo and

air conditioning surround starting at the bottom and moving towards the top.

Remove the passenger side door seal.

1

3

2

4

This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.

LOGAN

Microphone passage

Glue the bracket (supplied) to the windscreen, after having

thoroughly degreased the surface.

Run the cable under the headliner to the passenger side support.

Run the cable along the passenger side windshield support while

replacing the door seal.

Then pass the cable under the dashboard on the bottom of the

glove box.

1

3

2

4

5

To finish, run it to the radio housing.

This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.

LOGAN

Feeding the accessory cable

In the bottom of the glove box, insert the cable into the hole

next to the DIAG socket.

Then bring it out into the radio housing, taking care to leave

enough length.

1 2

This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.

LOGAN

ISO adapter

Fitting the hands-free system 1 / 2

On the kit connector (supplied), reverse the fuses (i.e. swap the red and orange wires) and

connect all the cables to the blue box as shown in the diagram below. Test everything before

reassembling...

1

...then store the box under the radio housing.

2

This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.

LOGAN

Fitting the hands-free system 2 / 2

Glue the bracket (supplied) under the cover of the central console

between the air vents, after carefully degreasing the surface.

Pass the cable into the air conditioning housing while clipping

the console cover (TAKE CARE to avoid cutting the screen cable).

Re-clip the assembly and insert the screen.

3

5

4

!

This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.

LOGAN

Testing

Before refitting the system, switch the kit on using the ignition (or by starting the car). By pushing the central knob of the remote control, check:

1 - that the menu is displayed on the screen (language or iPod etc) 2 - that the radio system is muted when the kit is in use (click in the blue box) 3 - that the sound through all speakers is properly muted 4 - that there is sound through the front speakers for spoken menus 5 - then turn off the ignition, verify that the kit turns off and that the message “goodbye” is displayed on the screen (otherwise reverse the fuses on the kit power supply harness) 6 - pair a telephone with the kit and make a call (check that both the microphone and the kit are working)

This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.

LOGAN

Reassembly

Refit the system using the following procedure: 1 - reconnect the connectors and the antenna to the radio and slide it into its housing.