LEON
This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.
LEON
Installation manual: Parrot MKi + Parrot CK3100 range
The brand name SEAT LEON and the SEAT logo are the property of the SEAT Group. This document is only valid for the vehicle model LEON® year 2009 to 2011, excluding all other models in the same range and excluding later modifications made to the vehicle by the manufacturer. The Parrot brand name and logos are the exclusive property of Parrot SA.
LEON
This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.
Disassembly 30min
Mounting kit 30min
Reassembly 30min
Testing 15min
Total 1h45min
NO +IGN
NO ISO
N/A UNIKA
FRONT LOUDSPEAKER TEL mode
ALL MUSIC mode
Fitting time (estimated) / Main features
Tools
-TORX screwdriver - Cutting pliers
- Crimping pliers - Multimeter or Test lamp
- Wire tie - Electrical tape - Soldering Iron
Plastic trim removal tools FACOM / BOJO
Accessories required
To get the most out of your hands-free kit we recommend that you update your software regularly. The update procedure can be found at
http://www.parrot.com/usa/support/downloads
Updating Updating
"Please contact your wholesaler to purchase accessories. A list of wholesalers is available at
www.certified.parrot.com. "
Kram ref. Dealer ref.
CK range 86 942 YY 138 CABL 2
MKi range 84 942 YY 138 CABL 2
Photos for illustration purposes
CK range MKi range
LEON
This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.
Disassembly
LEON
This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.
Disassembly 1 / 2
Using the plastic trim tools, unhook the left-hand side of the
rear-view mirror cover.
Using the plastic trim tools, unclip the radio surround.
Remove screws 1, 2, 3 and 4 around the car stereo, then
disconnect the connector and the aerial cables.
Unscrew screws 5 and 6 from the air conditioning unit.
5
6
Unclip the cover then remove it taking care not to disconnect anything
Place the cover on the top.
Unscrew screws 7, 8, 9 and 10 located at the top of the glove
box.
1
3
2
4
1
2
3
4 5 6
7 8 9 10
LEON
This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.
Disassembly 2 / 2
Unscrew screws 11 and 12 located under the glove box.
Using the plastic trim tools, unclip the cover underneath the
steering wheel.
Using the plastic trim tools, unclip the driver's side of the
dashboard.
Remove the door seal.
7
9
8
10
11 12
LEON
This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.
Finding an IGN wire
Using a guide, feed an electric wire from under the steering
wheel to the car stereo control housing. Feed the wire to the left
into the fusebox housing.
Fit a 1.5 mm terminal and insert it into one of the small fuse slots at
the top of the box (using a multimeter, check that the +12V
supply is indeed controlled by the ignition key).
Connect the +IGN using a male round terminal to the blue wire of the 84942 adapter in front of
the fuse holder or on the red
wire of the 86492 or
YY138CABL2 adapter.
1
3
2
LEON
This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.
Wiring the microphone
Using a guide, feed the cable from the cabin light to the windscreen. Glue the bracket (supplied) to the left of the rear-view mirror cover,
after having thoroughly degreased the surface.
Using a guide, feed the cable from along the windscreen under the
head liner.
Slide the cable along the driver's door pillar while replacing the
door seal.
Feed the cable through the fusebox.
4
5
Using a guide, feed the cable under the steering wheel towards the car stereo housing.
1
3
2
LEON
This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.
Feeding the accessory cable
On the top of the glovebox, break the cable blank.
Using a guide, feed the cable into the top part of the glove
compartment and towards the air conditioning control unit housing.
1 2
Then feed the cable being careful to leave enough length.
3
LEON
This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.
Fitting the hands-free system 1 / 2
Bring out the original connector from below and slide it towards the top in the air conditioning housing. Then feed the adapter connector to the radio. Connect the adaptor to the original connector and connect all of the wires to the blue box as shown in the diagram below. Test the assembly before completing fitting and then slide everything behind the air conditioning control unit.
1
Direct adaptor cable
LEON
This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.
Fitting the hands-free system 2 / 2
Glue the bracket (supplied) to the top-left corner of the radio
surround.
When reassembling TAKE CARE not to cut the wire with the radio
fixings.
Then position the screen.
2
4
3
12
!
LEON
This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.
Testing
Before refitting the system, switch the kit on using the ignition (or by starting the car). By pushing the central knob of the remote control, check: 1 - that the menu is displayed on the screen (language or iPod etc) 2 - that the radio system is muted when the kit is in use (click in the blue box) 3 - that the sound through all speakers is properly muted 4 - that there is sound through the front speakers for spoken menus 5 - then turn off the ignition, verify that the kit turns off and that the message “goodbye” is displayed on the screen (otherwise reverse the fuses on the kit power supply harness) 6 - pair a telephone with the kit and make a call (check that both the microphone and the kit are working)
LEON
This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.
Reassembly
Refit the system using the following procedure: 1 - refit the cover on the left-hand side of the dashboard 2 - refit the cover under the steering wheel 3 - clip back the air conditioning surround and replace screws 5 and 6 4 – reconnect the adaptor and the aerials behind the car stereo and slip them inside the housing (make sure that you do not trap and cut any screen wires) 5 - refit the 4 screws (1, 2, 3 and 4) for the car stereo 6 - refit the radio surround, paying attention to the screen cable 7 - replace the glove box and replace the 6 screws (7, 8, 9, 10, 11 and 12) 8 - retest to check that the system is working correctly