Date post: | 08-Apr-2016 |
Category: |
Documents |
Upload: | andrey-das |
View: | 216 times |
Download: | 2 times |
Training poi manufacturing tutorial directed by Gustave for Burncrewconcept.net ß1
DIY training poi
Material 8 2 tennis balls (hollow) 8 2 laces (a length at least equal to 70 cm) 8 2 caps in plastic bottles (optional)
Tools 8 A knife (sharp) /! \ Ask to an adult! /! \ 8 A lighter 8 A drill (optional)
ß2 Training poi manufacturing tutorial directed by Gustave for Burncrewconcept.net
Creating two parallel slots 8 To do this, it is necessary with the knife that is planted in our ball and create two slots of about 1 cm in length. 8 It is not necessary to force the knife should go smoothly.
a Do not do alone, ask an adult to help you, not hurt you.
The attachment of the rope on the weight
8 Slide the cable into one of the slots the ball to make it out through the other slot. 8 It then only remains to tie a knot with the two ends of the lace. I opted for a hangman’s knot, but there are others.
Training poi manufacturing tutorial directed by Gustave for Burncrewconcept.net ß3
Strap 8 This is to make a simple loop
with the rope. Then slips it between his fingers.
Handle 8 Please have a plastic bottle cap, make a hole in its center (using a drill, a metal tip that we will be heated, a tip and a hammer etc.) 8 The hole should not be larger than the size of your lace! 8 Slide the lace in taking care to have the top of the cap facing the bolas. Then come and make a knot at the desired length. Cut off the excess
lace or tie a knot to ‘park’ the surplus of the lace, it will change the length of the rope to your envy!