Mini 4
For more information please visit
www.Spida.com
Square 1 Design & Manufacture Inc.A: 400 N. Forsythe Street · Franklin, IN 46131P: 866-647-7771 · E: [email protected]
Mini 4
Used for:4ft wide, 30t capacity. Press head design allows you to use the 30t anywhere on the press head. Can be used for any pressing in the factory, including floor truss pressing. The 4ft width allows low pitch trusses to be made on this machine.
© Spida · Mini 4 · June2017
Front view
Top view
5ft 6
in
4ft
3ft 3
in
36ft 9in
34ft 5in 2ft 3in
4ft 1
1in
Specifications Press head travelling speed 9ft 10in / minute
Press head capacity 30 tonne @ 1800PSI
Press head opening 6in max 1in min
Platen size 17.7in
Pressing cycle 3 seconds
Motor 15 hp
Table size 34ft 5in x 4ft
Weight 4000 kg (Approximately)
Power requirements 32 amp, 415v, 3 phase +N +E
Features• Able size 36ft x 4ft (Standard Table size)
• Working area 33ft x 4ft
• Bolt on jigging
• Safety laser beam
• Bell Crank pressing action
• Platen size 47.2in x 17.7in
Options• Table length 22ft, 26ft, 29ft or
• Customised table length (built to order)
• Pneumatic floor strut jigging