No TóxicoProtección de congelación a -60°F (-51°C)Protección de ruptura a -100°F (-73°C)Inhibidor de corrosión de grado alimenticio70% de Glicol
PRODUCT N°
PG-100
1 U.S. Gallon (3.78 Liters)
PRODUCT NO.
PG-100
Non-Toxic-60°F Freeze Protection-100°F Burst ProtectionFood Grade Corrosion Inhibitors70% Glycol
Propylene GlycolHeat Transfer Fluid
No TóxicoProtección de congelación a -60°F (-51°C)Protección de ruptura a -100°F (-73°C)Inhibidor de corrosión de grado alimenticio70% de Glicol
Propilen GlicolFluido para Transferencia de Calor
Glycol
ProTek-100™ ProTek-100™
See Side Panel for Additional Cautions
FOR PROFESSIONAL USE ONLY
KEEP OUT OF REACH OF CHILDREN
Glicol
(1 US Gallon = 3,78 Litros)
Vea el anverso para precauciones adicionalesDESARROLLADO SOLO PARA USO PROFESIONALMANTENGASE ALEJADO DEL ALCANCE DE LOS NIÑOS
MADE IN USADOC32166
DESCRIPTION:ProTek-100™ is an inhibited propylene glycol based industrial heat transfer fluid and antifreeze that contains food grade corrosion inhibitors. It is suitable for use in potable water systems. ProTek-100™ is designed to provide freeze and burst protection, excellent thermal conductance, protection against corrosion and fouling and long term stability in closed recirculating water loops. ProTek-100™ provides burst protection to -100°F. Freeze points and burst points are controlled by the propylene glycol to water ratio.
DIRECTIONS:Clean and passivate new or fouled systems with Triple Treat™ before adding ProTek-100™ to the system. After the system is clean, fill with ProTek-100™ and good quality water in the ratio that will give the desired freeze or burst protection. Circulate the glycol solution through the system. After it has thoroughly mixed, test the solution to ensure that the system has the desired freeze or burst protection.
Recommended Mixing Rates ProTek-100™ % Propylene Freeze Point / Water Ratio Glycol Content Burst Point Flow Point Full Strength 70 -60°F/-100°F -70°F 5:2 50 -29°F/-80°F -50°F 4:3 40 -8°F/-60°F -35°F 1:1 35 2°F/-50°F -20°FProTek-100™ solutions remain pumpable down to the minumum flow points listed. For additional information on ProTek-100™, consult the Technical Data Sheet and the Safety Data Sheet.CAUTION: Contains inhibited propylene glycol (CAS# 57-55-6). Avoid eye contact or prolonged skin contact. Skin and eye protection are recommended when mixing and handling solutions of this compound. Do not take internally.FIRST AID: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If irritation occurs: Get medical advice. IF ON SKIN: Wash with soap and water. IF SWALLOWED: Immediately drink 3 or 4 glasses of water. Get medical attention if you feel unwell.
NON-WARRANTY: This product is provided "as is". Seller specifically disclaims any and all warranties, whether expressed, implied, statutory or otherwise and specifically disclaims all implied warranties including without limitation, any implied warranties of merchantability or fitness for a particular purpose or those arising by reason of custom or usage in the trade or by course of dealing.
DiversiTech Corporation6650 Sugarloaf Parkway, Duluth, GA 30097
678-542-3600 www.diversitech.com800.995.2222 for Customer Service
800.255.3924 for Chemical Emergencies 02
9524714143
DESCRIPCION: ProTek-100™ en un fluido de transferencia de calor y anticongelante en base a propilen glicol inhibidor industrial el cual contiene inhibidores de grado alimenticio. Adecuado para usar en sistemas de agua potable. ProTek-100™ es diseñado para brindar protección de congelamiento y ruptura, excelente conductancia térmica, protección contra la corrosión e incrustaciones por un largo período de tiempo en sistemas cerrados de recirculación de agua. ProTek-100™ protege la ruptura incluso a temperaturas por bajo los -100°F (-73°C). Tanto los puntos de congelamiento como de ruptura son controlados por la mezcla proporcional de agua y propilen glicol.
INSTRUCCIONES DE USO: Antes de aplicar ProTek-100™ sobre sistemas nuevos o incrustados limpie y pasive las superficies utilizando para tal efecto Triple Treat™. Una vez que el sistema se encuentre limpio, rellene con ProTek-100™ y agua de buena calidad en la proporción adecuada para obtener la protección contra congelamiento o ruptura deseada. Haga circular la solución de glicol a través del sistema. Después de efectuada la mezcla pruebe la solución para asegurar que el sistema tiene la protección de congelamiento o ruptura adecuada
Proporciones de Mezclas recomendadas
Las soluciones de ProTek-100™ permanecen bombeables hasta el flujo mínimo de los puntos enumerados.Para información adicional de seguridad y manipulación de ProTek-100™ consulte la hoja de seguridad (SDS).PRECAUCIONES: Contiene Propilen glicol inhibido (CAS# 57-55-6). Evite el contacto con los ojos o el prolongado contacto con la piel. Cuando manipule o efectúe mezclas de este producto utilice elementos de protección personal para ojos y piel. No lo ingiera.PRIMEROS AUXILIOS: AL CONTACTO CON LOS OJOS: Enjuagar meticulosamente con agua durantevarios minutos. Si tiene lentes de contacto y resulta fácil de hacer, quitarlos. Seguir con el enjuague. En caso de irritación: obtener atención médica. AL CONTACTO CON LA PIEL: Lavar con agua y jabón. EN CASO DE INGESTIÓN: Beber inmediatamente 3 o 4 vasos de agua. Obtener atención médica si siente malestar.NO GARANTIZADO: Este producto se proporciona “tal cual”. El vendedor declina expresamente de todas y cada una de las garantías, ya sean expresa, implícita, legal o de otra manera y renuncia específicamente a toda garantía implícita, incluyendo sin limitación, cualquier garantía implícita de comerciabilidad o idoneidad para un propósito particular o las derivadas por la razón de la costumbre o el uso en el comercio o por los usos habituales.
Fabricado en los EE.UU Servicio al cliente: 800.995.2222Emergencias químicas: 800.255.3924
Non-Toxic-60°F Freeze Protection-100°F Burst ProtectionFood Grade Corrosion Inhibitors70% Glycol
B81-484
Minimum ProTek-100™ Proporción de
Agua
Máxima intensidad
5:2
4:3 1:1
Punto deCongelamiento /Punto de Ruptura
-60°F/-100°F(-51°C/-73°C)-29°F/-80°F
(-34°C/-62°C)-8°F/-60°F
(-22°C/-51°C)2°F/-50°F
(-17°C/-46°C)
Punto de Caudal mínimo
-70°F(-57°C)-50°F
(-46°C)-35°F
(-37°C)-20°F
(-29°C)
% de Contenido de Propilen
Glicol
70
50
40 35