representing Quaser Mold / Die Vertical Machining Centers

YMT (Brea, CA) is the importer of Quaser

high speed vertical machining centers.

YMT’s parts room (Brea, CA) is stocked with parts and

accessories for Quaser machining centers.

Most parts can arrived next day if needed.

VMC Technologies is theexclusive Michigan sales representative for Quaser machining centers.

VMC Technologies service dept. provides local service in Michigan for Quaser high speed mills.

What are High Speed Machining Centers

High speed machining centers are also referred as high speed mills, hard milling and die / mold machining centers.

They are often used to machine dies and molds using a very high speed spindle which can machine parts in their hardened state.

Advantages: Die / Mold Machining Centers

Machine Complex Partsmulti-axis machining makes it possible machine parts that otherwise have to be casted which required expensive tooling

Reduce Set Up TimeParts can be machined in only one fixture which saves time but also reduces operator error & tooling cost.

Less CompetitionSince not many shops have multi axis capabilities there’s less competition which means you can charge more & increase profits.

VALUE – HIGH PRECISION – QUALITY – EASE of USE - DESIGN

#5 Reasons to consider Quaser multi axis machining centers?

#1.VALUE: Quaser multi axis marching centers were originally developed for Europe market where they compete with German machines. So, they are very close matched or better than the German made units, but at a lower price.

#2.HIGH PRECISION: Quaser machines provide top notch

repeatable precision and accuracy. A lot of builders makes "muscle machines" with ridiculous specs but lose the ability to maintain needed accuracy. This maybe good for some markets

where they only need rough machining.

Quaser is aimed at the high precisionmarkets such as aerospace and medical.They are trying to build machines thatare in the "Zen" balance between

performance and precision.

#3.QUALITY: Quaser spends most of its revenue on R&D techniques like advanced CAD & Finite Analysis simulation software. All machines machines are built in-house are subject to pass the toughest inspection list and 48 hours continuous burn-in test before they are ready to ship out.

#4.EASE of USE: We often get the remarks "This is the easiest machine I ever operated.”

#5.DESIGN: Quaser rigid

cast designs are hand scrapped

and can withstand any

machining environment.

High Speed Machining CentersRequest Info.

model MV154 MV184X,Y,Z axis travel 30”x 19.7”x 22” 40.2” x 24” x 24”

spindle 24,000 rpm 24,000 rpm

also produces the following types of quality machining centers

vertical horizontal multi axis multi pallet

1788 Northwood DriveTroy, MI 48084www.vmctechnologies.cominfo@vmctechnologies.com

call 248-786-3000