+ All Categories
Home > Documents > R-9976pbautoelectrics.co.uk/wp-content/uploads/2015/06/...R-9976 is now available in three different...

R-9976pbautoelectrics.co.uk/wp-content/uploads/2015/06/...R-9976 is now available in three different...

Date post: 20-Feb-2021
Category:
Upload: others
View: 8 times
Download: 0 times
Share this document with a friend
4
The perfect solution when you can’t run the compressor directly from the engine. The R-9976 requires no belts, minimizes A/C hose length while maximizing performance. R-9976 COMPRESSOR Red Dot Model R-9976 HYDRAULIC Axial Direct Drive
Transcript
  • The perfect solution when you can’t run the compressor directly from the engine. The R-9976 requires no belts, minimizes A/C hose length while maximizing performance.

    R-9976C O M P R E S S O R

    Red Dot Model R-9976

    HYDRAULICAxial Direct Drive

  • 1 square = 1⁄2”1 square = 1⁄2”

    INLET

    15.45” 392mm

    6 3⁄16”157mm

    8”185mm

    6 5⁄16”160mm

    ”3 5⁄1684mm

    45°45°

    WARNING: Red Dot Corporation takes no responsibility for modifications to the vehicle’s hydraulic systems. All hydraulic modifications must be done by a certified hydraulic technician.

    Mounting AnglesClock mounting limited to 45°

    New for 2015, the updated R-9976 is now available in three different motor sizes:R-9976-5P = 8cc/rev (same as current dash-3 assembly)R-9976-6P = 14cc/revR-9976-7P = 23cc/rev

    The new hydraulic motors have integrated on/off solenoid valve and bypass circuit offering greater hydraulic flow range flexibility and greater hydraulic pressure range flexibility.

    Earlier versions used an external valve to control the flow of hydraulic fluid to the unit. Red Dot’s new design has an on/off valve and bypass circuit built into the motor making it easier to connect only three hydraulic lines; earlier models required as many as seven lines. And the R-9976 requires no external control valves or bypass circuits.

    With fewer components and hydraulic connections, the new design is simpler to install and eliminates several potential leak points

    Although the overall unit has a slightly larger footprint, the mounting plate itself is the same as previous installations.

  • SPEED8cc/rev

    PRESSURE

    SPEED14cc/rev PRESSURE

    SPEED23cc/rev PRESSURE

    0

    250

    500

    750

    1000

    1250

    1500

    1750

    0

    500

    1000

    1500

    2000

    2500

    3000

    3500

    1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20

    Hydraulic Oil Pressure

    (psig)

    Motor Speed (RPM)

    Hydraulic Oil Flow (GPM)

    Based on Published Compressor Curves

    HYDRAULIC FLOW & PRESSURE CURVESIt is important to choose the correct assembly based on available hydraulic system pressure and flow rate.

    C O M P R E S S O RRed Dot Model

    R-9976HYDRAULIC

    Axial Direct Drive

    Every R-9976 ships with both 12 and 24 volt coils and the wiring harness to connect it to your vehicle’s electronics.

  • ElaineBeardallTypewritten text51 Hermitage WayHermitage Industrial EstateMansfieldNottinghamshire NG18 5ESTel: 01623 659311Email: [email protected]: www.pbautoelectrics.co.uk


Recommended