• Shovel it • Protect it • Wax it • Grab it • Strain it • Test it • Burn it • Cover it • Saw it • Torch it • Light it • Seal it • Torque it • Connect it • Sink it • Clean it • Caulk it • Tie it • Insu-late it • Push it • Bend it • PlumBite it • Strap it • Save it • Plug it • Tape it • Strike it • Drain it • Join it • Shim it • Waste it • Cut it • Pack it • Flush it • Brush it • Bolt it • Hang it • Glue it • Mark it • Hose it • Clamp it • Bag it • Get it • Ship it • Gas it • Prime it • Unclog it • Lev-el it • Weld it • Tap it • Drill it • Seat it • Pull it • Twist it • Spray it • Stock it • Flare it • Turn it • Measure it • Tote it • Crimp it • Pump it • Hook it • Foam it • Fit it • Fill it • Repair it • Flange it • Tee it • Plumb it • Valve it • Couple it • Pipe it • Pex it • Lube it • Trap it • Solder it • Drain it •Paint it • Meld it • Dig it • Gauge it • Reach it • Paste it •Spark it • Key it • Dome it • Wipe it • Expand it • Wrap it • Reduce it • Box it • Trim it• Wear it • Vent it • Cap it • Extend it • Shower it • Float it • Guard it • Nail it • Ham-mer it • Sand it • Coat it • Funnel it • Replace it
01191-01
2
www.jonesstephens.com
JSC North • 50 Keystone Blvd. East • Pottsville, PA 17901Phone: 1-800-325-8999 • Fax: 1-866-922-0076
JSC South • 3249 Moody Pkwy • Moody, AL 35004 Phone: 1-800-355-6637 • Fax: 1-800-462-6991
New Products from Jones Stephens 1st Quarter
Self Sealing White Foam Insulation
• 1/2” Wall • 100% Closed cell polyethylene• Cartons shippable via UPS• All sizes also available in black
Part No. Nominal ID
R Values CTS IPS FT/Box List Price
I53058W 5/8” 3.345 1/2” 3/8” 306 $252.45
I53078W 7/8” 3.107 3/4” 1/2” 240 $227.48
I53118W 1-1/8” 4.865 1” 3/4” 180 $195.80
I53138W 1-3/8” 2.822 1-1/4” 1” 150 $183.08
I53158W 1-5/8” 2.737 1-1/2” 1-1/4” 120 $171.84
I53178W 1-7/8” 2.672 - 1-1/2 90 $143.84
I53218W 2-1/8” 2.62 2” - 84 $157.50
I53312W 3-1/2” 2.549 - 3” 48 $125.65
I53412W 4-1/2” 2.399 - 4” 30 $115.88
I53418W 4-1/8” 2.418 4” - 30 $128.86
Plunge Right
Part No. Description CTN/MSTR List Price
J40016 2 Hole Plunge Right 1 $26.18
J40017 1 Hole Plunge Right 1 $26.18
• 0-160 PSI• 3/4” Female hose
thread connection• Indicator arm• Steel case with 2-1/2”
shatterproof face
Water Test Gauge
Part No. Description CTN/MSTR
List Price
J663020-160 PSI Water Test Gauge
with Indicator1/50 $16.18
Dual Scale Boiler Gauge
• 0-75 PSI• 60-320° F, 20-160° C• Center back mount• 1/4” MPT connection
Part No. Description CTN/MSTR List Price
J405753-1/2” 0-75 PSI Dual Scale
Boiler Gauge1/50 $17.22
SPECIALTIES & REPAIR
SECTION B
ASAP Basket Strainer• Ideal for quick installation • Can be installed in less than
one minute• Brass slip nut• Galvanized retaining ring• Galvanized locking ring• Durable stainless construction
Part No. Description CTN/MSTR List Price
S14009ASAP Chrome Plated
Basket Strainer1/24 $18.75
S1409BN ASAP Brushed Nickel Basket Strainer 1/24 $28.75
MISC. PLUMBING SPECIALTIES
SECTION C
• Easily unplug a clogged drain
• Eliminates use of rag to plug overflow
• Seal allows for full utilization of pressure to remove clog
• Reusable
New Products from Jones Stephens 1st Quarter
3
www.jonesstephens.com
JSC North • 50 Keystone Blvd. East • Pottsville, PA 17901Phone: 1-800-325-8999 • Fax: 1-866-922-0076
JSC South • 3249 Moody Pkwy • Moody, AL 35004 Phone: 1-800-355-6637 • Fax: 1-800-462-6991
• LEAD FREE• Listed by Warnock Hersey• Meets ASTM F2159, F877 & CSA B137.5• Will not rust or corrode
• Unaffected by household cleaners and chemicals
• Smooth interior for better water flow• Resists scale build-up
Black Plastic Pex
Plastic Pex Adapter
Plastic Pex Tee
Plastic Pex Plug
Plastic Pex TeeBlack Part # White Part # Part Description CTN/MSTR List Price
C76762 C76700 1/2” Plastic Pex Tee 50/400 $1.25
C76763 C76701 3/4” Plastic Pex Tee 50/400 $2.50
Plastic Pex ElbowBlack Part # White Part # Part Description CTN/MSTR List Price
C76751 C76702 1/2” Plastic Pex Elbow 50/500 $1.00
C76752 C76703 3/4” Plastic Pex Elbow 50/500 $1.78
C76753 C76720 1” Plastic Pex Elbow 50/500 $4.64
Plastic Pex CouplingBlack Part # White Part # Part Description CTN/MSTR List Price
C76754 C76704 1/2” Plastic Pex Coupling 50/1000 $0.75
C76755 C76705 3/4” Plastic Pex Coupling 50/1000 $1.03
C76756 C767063/4” x 1/2”
Plastic Pex Coupling50/1000 $1.14
C76757 C76722 1” Plastic Pex Coupling 50/1000 $2.38
C76758 C76723 1” x 3/4” Plastic Pex Coupling 50/1000 $2.38
Black Part # White Part # Part Description CTN/MSTR List Price
C76759 C767071/2” PEX x 1/2” MPT
Plastic Adapter25/300 $1.90
C76760 C767083/4” PEX x 3/4” MPT
Plastic Adapter25/300 $2.45
C76761 C767271” PEX x 1” MPT Plastic Adapter
25/300 $4.64
Black Part # White Part # Part Description CTN/MSTR List Price
C76764 C767091/2” x 1/2” x 3/4”
Plastic Pex Tee25/300 $2.01
C76765 C767103/4” x 1/2” x 1/2”
Plastic Pex Tee25/300 $1.89
C76766 C767113/4” x 1/2” x 3/4”
Plastic Pex Tee25/300 $2.11
C76767 C767123/4” x 3/4” x 1/2”
Plastic Pex Tee25/300 $2.11
Black Part # White Part # Part Description CTN/MSTR List Price
C76768 C76740 1/2” Plastic Pex Plug 100/2000 $0.68
C76769 C76741 3/4” Plastic Pex Plug 100/2000 $1.11
FITTINGS & VALVES
SECTION D
LEAD FREE
4
www.jonesstephens.com
JSC North • 50 Keystone Blvd. East • Pottsville, PA 17901Phone: 1-800-325-8999 • Fax: 1-866-922-0076
JSC South • 3249 Moody Pkwy • Moody, AL 35004 Phone: 1-800-355-6637 • Fax: 1-800-462-6991
New Products from Jones Stephens 1st Quarter
Gear Clamp• New size #6 (3/8”-7/8”)• 8 mm band• All stainless steel• Hanging bag• Also available in trade size 6
through 104• CARTON QUANTITIES ONLY
Part No. Description CTN/MSTR List Price
G16006#6 (3/8”-7/8”) Stainless
Steel Gear Clamp200/2000 $0.95
FITTINGS & VALVES
SECTION D
TUBULAR
SECTION T
Double Offset Tailpiece
• Slip joint on both ends• UPC listed
Part No. Description CTN/MSTR List Price
P371501-1/2” PVC Slip Joint
Double Offset Tailpiece1/40 $6.91
E-Z STROKE SAW
FEATURED PRODUCT
The E-Z Stroke Saw by Jones Stephens uses a pull-stroke cutting action to deliver a smooth, fast and accurate cut. Available in both 8” and 12”, this pipe saw can be used to cut plastic, lead and copper pipe flush against the floor without having to
use offset adapters. The blade is manufactured of flexible durable carbon steel and features tri-edge teeth that deburr as it cuts. Need a replacement blade? No problem. We offer replacement blades without screws that hook easily into the handle. With
COMMERCIAL / RESIDENTIAL PLASTICS
SECTION E
Shower Drain w/ NB Square
Strainer• Fits over 2” or inside 3”
Schedule 40 DWV pipe• Low profile for first and second
floor installation• Reversible clamping ring
for additional 1/2” height adjustment
• Brass inserts ensure secure clamping of membrane
• Dual weeps holes• Recessed sump area for added
drainage• Square strainer allows for easier
tiling on floor
Part No. Description CTN/MSTR List Price
D501412” x 3” PVC Shower/Floor Drain
with 4” NB Square Strainer & Collar1 $37.22
*Sales flyer available upon
request
S49005 S49007
S49005: 8” E-Z Stroke Pipe SawS49006: 8” Replacement BladeS49008: 12” E-Z Stroke Pipe SawS49007: 12” Replacement Blade
its many features, the E-Z Stroke Saw is great to have in your toolbox for multiple applications. Visit www.jonesstephens.com for more information and remember to look for the easily identifiable orange handle.
NEW SIZE
Shower Drain w/ Round Strainer
• New! Gray spud to camouflage dirt and soap scum
• New! Ability to use a snap-in OR screw-in strainer
• Fits over 2” or inside 3” Schedule 40 DWV pipe
• Low profile for first and second floor installations
• Beveled edge allows for recessed installation
• Reversible clamping ring for additional 1/2” height adjustment
• Brass inserts ensure secure clamping of membrane
• Dual weeps holes• Recessed sump area for added
drainage• UPC listed
Part No. Description CTN/MSTR List Price
D500012” x 3” PVC Shower/Floor Drain
with 4” SS Round Strainer20 $15.48
NEW & IMPROVED