1
Bearing 5x 10x4mm (HC411-S) Uniball M2.5x 5H6 (H0064-S) Spacer 5x 9x0.75mm (H0330-S) Tail Rotor Hub Assembly Tail Blade Grip Assembly Tail Pitch Slider Link Assembly Tail Pitch Slider Link Assembly ( Not included in H0324-S ) Tail Pitch Slider Assembly Buttom Head Cap Screw M4x6mm Tail Pitch Slider Link (H0261-S) Tail Blade Grip (H0327-S) Spindle Shaft (H0329-S) Oring (HC335-S) Tail Shaft (H0325-S) Tail Rotor Hub Assembly Spacer 5x 9x0.75mm (H0330-S) Thrust Bearing 5x 10x4mm (HC435-S) Bearing 5x 10x4mm (HC411-S) Socket Head Cap Screw M2x6mm (HC004-S) Buttom Head Cap Screw M4x6mm (HC096-S) Note: Smaller ID Note: Larger ID Spacer 7.5x 10x0.5mm (H0349-S) Socket Head Cap Screw M2x6mm (HC004-S) Spacer 2x 3x3mm (H0076-S) Note: S >> Left Side Note: S >> Right Side Socket Head Cap Screw M2x6mm ...x2 ...x4 Note: It is a normal for the tail to feel a bit tight after initial assembly as the tail spindle preload is ussually high when the helicopter is brand new. The preload will loosen up after 2-5 flights allowing the system to become smooth. Spare Parts H0325-S Tail Rotor Shaft With Tail Hub Assembled x 1pc. HC153-S Cup Point Set Screws M4x6mm x 1pc. HC335-S Tail Hub Oring x 2pcs. H0327-S Aluminum Tail Grip x 2pcs. HC411-S Bearing Ø5xØ10x4mm x 4pcs. HC435-S Thrust Bearing Ø5xØ10x4mm x 2pcs. HC096-S Button Head Cap Screw M4x6mm x 2pcs. HC004-S Socket Head Cap Screw M2x6mm x 2pcs. HC330-S Spacer Ø5xØ9x0,75mm x 2pcs. HC349-S Spacer Ø7,5xØ10x0,5mm x 2pcs. Copyright@2013 - SAB Heli Division - All rights reserved TAIL ROTOR [H0324-S] Manual
