ZENA mobile welding system -- Operators Manual -- Series 150 & 200 Welders -- Appendix B
49
Lawn tractor engine with mounting bracket assembly installed (using two spacers and longer bolts to replacebolts which hold starter motor onto engine).
Pulley installed using bolt holes onflywheel & enlarging holes on pulleyto accommodate bolt pattern.
Top view of mounting bracket assembly.
Engine with all components installed --ready to weld.
Side view of engine showing PowerGenerator wiring (all componentsinstalled).
ZENA mobile welding system -- Operators Manual -- Series 150 & 200 Welders -- Appendix B
50
G. Welder Installed in a Model L2350 Kubota® Tractor
View showing brackets and spacersused to support top and bottom of
Power Generator
In this installation, the base of the PowerGenerator is attached to the existing alternatorusing simple site-fabricated straps and spacers.Support and tensioning are provided by aturnbuckle mounted to another easily fabricatedbracket. (Drawings that show thesecomponents in detail are provided on the nextpage.)
View showing brackets and spacers attachedto existing alternator which are used to
support the bottom of the Power GeneratorBracket used to support to Power Generator and to
provide a mechanism for V-belt tensioning
ZENA mobile welding system -- Operators Manual -- Series 150 & 200 Welders -- Appendix B
51
H. Kubota® Model 2350 Tractor Installation Bracket Set
Spacers
Rear Base Support Bracket
Support/Tensioning Turnbuckle
Front BaseSupport Bracket
Turnbuckle Support Bracket
ZENA mobile welding system -- Operators Manual -- Series 150 & 200 Welders -- Appendix B
52
I. Ford® Tractor Installation
In this installation, to make it easy for the ownerto use the welder on multiple vehicles, a doublepulley was attached to the tractor’s existingalternator. Then a turnbuckle was installed toprovide support and tensioning. One end of theturnbuckle is attached to a small bracket(fabricated from scrap stock) which wasattached the vehicle’s existing alternator supportbolts, the other is attached to the PowerGenerator.
A Universal Mounting Bracket was used to mount thePower Generator to a fabricated bracket assembly
ZENA mobile welding system -- Operators Manual -- Series 150 & 200 Welders -- Appendix B
53
J. Construction Details - Dual Vacuum Actuator Bracket for Cummins Diesel Inst.