Date post: | 05-Jan-2016 |
Category: |
Documents |
Upload: | sabina-owens |
View: | 212 times |
Download: | 0 times |
January 2006
C. Liu et.alSlide 1
doc.: IEEE 802.15-15-06-040-00-003c
Submission
Project: IEEE P802.15 Working Group for Wireless Personal Area Networks (WPANs)Project: IEEE P802.15 Working Group for Wireless Personal Area Networks (WPANs)
Submission Title: [Desktop Channel Measurements and Models]Date Submitted: [18 January, 2006]Source: [C. Liu, E. Skafidas, T. Pollock, K. Saleem] Company [NICTA]Address [Dept of Electrical and Electronic Engineering, University of Melbourne, Parkville Victoria 3010]Voice:[+61 3 8344 8407], E-Mail: [[email protected]]
Re: []
Abstract: [Overview of Channel Measurements and Channel Model for 60GHz Desktop Channel]
Purpose: [Contribution for 802.15.3c Task group ]
Notice: This document has been prepared to assist the IEEE P802.15. It is offered as a basis for discussion and is not binding on the contributing individual(s) or organization(s). The material in this document is subject to change in form and content after further study. The contributor(s) reserve(s) the right to add, amend or withdraw material contained herein.Release: The contributor acknowledges and accepts that this contribution becomes the property of IEEE and may be made publicly available by P802.15.
January, 2006
January 2006
C. Liu et.alSlide 2
doc.: IEEE 802.15-15-06-040-00-003c
Submission
Introduction
• Numerous desktop measurement made• Measurements were made at different times
and location on the same and different desktops
• The Saleh-Valenuela (S-V) model is used to model the desktop environment.
• Key S-V model parameters such as Cluster Decay Factor, Ray Decay Factor, Cluster Arrival Rate, and Ray Arrival Rate are extracted from the measured data.
January 2006
C. Liu et.alSlide 3
doc.: IEEE 802.15-15-06-040-00-003c
Submission
Measurement Setup
• An Anritsu 37397 Vector Network Analyzer (VNA) was used to measure the channel transfer function.
• The outputs of the amplifiers where connected to the antennas used in the experiment.
• The two antennas were mounted on tracks and the directional receive antenna was attached to an electronically steerable platform that permitted the angle of the antenna to be precisely and automatically controlled
• In this setup the VNA was set to sweep between 55-65GHz with a frequency step of 6.25MHz for 1601 data points.
January 2006
C. Liu et.alSlide 4
doc.: IEEE 802.15-15-06-040-00-003c
Submission
Measurement Setup
• An omni-directional antenna is employed at the transmitting side • A 21dBi directional pyramidal horn antenna at the receiving
side. • The antennae voltage standing wave ratios were better than
1.5:1 over the entire frequency of interest. • The antennae were mounted on rails that permit the precise and
automatic positioning required at 60 GHz (5mm wavelength). • For AoA measurements a directional antenna was mounted on
an electronically steerable platform for precise angular measurements from 0 to 360 degrees in 4 degree steps.
• For each angle the time impulse response was be measured.
January 2006
C. Liu et.alSlide 5
doc.: IEEE 802.15-15-06-040-00-003c
Submission
Measurement Setup
Port 1 Port 2
GPIB Interface
Transmitting Antenna
Receiving Antenna
60 GHz Cable
60 GHz Propagation Channel
Vector Network Analyzer
Control and Data Collection
60 GHz Cable
amplifier
January 2006
C. Liu et.alSlide 6
doc.: IEEE 802.15-15-06-040-00-003c
Submission
Measurements
January 2006
C. Liu et.alSlide 7
doc.: IEEE 802.15-15-06-040-00-003c
Submission
Measurements
• Angle of Arrival Profile for the desktop pictured in Figure 1.
• Note that signal is received in multiple angles in azimuth.
January 2006
C. Liu et.alSlide 8
doc.: IEEE 802.15-15-06-040-00-003c
Submission
Measurements
• Power delay profile measured at desk pictured in Figure 1.
• Note the delay and relative reduction of power of the signal received at 308 degrees in azimuth.
January 2006
C. Liu et.alSlide 9
doc.: IEEE 802.15-15-06-040-00-003c
Submission
Model
• SV model– cluster arrival rate– ray arrival rate (within each cluster)– cluster decay factor– ray decay factor– cluster and ray log-normal standard
deviation
January 2006
C. Liu et.alSlide 10
doc.: IEEE 802.15-15-06-040-00-003c
Submission
Parameter Extraction
• Normal probability plot of the log of the power amplitude of rays received within a cluster.
January 2006
C. Liu et.alSlide 11
doc.: IEEE 802.15-15-06-040-00-003c
Submission
Parameter Extraction
• Plot of log of Cluster Power versus time.
• Gradient is equal to inverse of Cluster Decay factor.
January 2006
C. Liu et.alSlide 12
doc.: IEEE 802.15-15-06-040-00-003c
Submission
Parameter Extraction
• Plot of log of Ray Power versus time.
• Gradient is equal to inverse of Ray Decay factor.
January 2006
C. Liu et.alSlide 13
doc.: IEEE 802.15-15-06-040-00-003c
Submission
Extracted SV parameters
• Parameters– cluster arrival rate 0.30– ray arrival rate (within each cluster) 8.73– cluster decay factor 1.47– ray decay factor 1.00(dB),– cluster log-normal standard deviation 2.1– ray log-normal standard deviation 2.4